曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

External lighting consists of landing, taxi, navigation, beacon, anti-collision strobe, logo and
wing inspection lights. Control of the landing and taxi lights is provided by switches on the
LANDING LTS panel located on the overhead panel. All other external lighting is controlled
by switches on the EXTERNAL LTS panel, also located on the overhead panel. <0020><0021>
REV 56, Jan 31/03
Vol. 1 17--50--2
LIGHTING
External Lighting
Flight Crew Operating Manual MASTER
CSP A--013
External Lighting <MST>
Figure 17---50---1
NAVIGATION
LIGHTS
(RED)
NOSE
LANDING
LIGHT (2)
WING LANDING
LIGHT LEFT
TAXI--RECOGNITION
LIGHT LEFT
WING LANDING
LIGHT RIGHT
TAXI--RECOGNITION
LIGHT RIGHT
LOGO LIGHTS
(WHITE)
<0020>
WING INSPECTION
LIGHT (WHITE)
(TWO PLACES)
NAVIGATION
LIGHTS
(GREEN)
STAIR LIGHTS
(WHITE)
LANDING
LIGHTS
(WHITE)
NAVIGATION
LIGHT (WHITE)
ANTICOLLISION/NAVIGATION
LIGHT (WHITE)
ANTICOLLISION LIGHT
(WHITE)
ANTICOLLISION
LIGHT
(WHITE)
ANTICOLLISION
BEACON LIGHT
(RED)
<0021>
ANTICOLLISION
BEACON LIGHT
(RED)
<0021>
Vol. 1 17--50--3
REV 56, Jan 31/03
LIGHTING
External Lighting
Flight Crew Operating Manual
CSP A--013
MASTER
A. Landing and Taxi Lighting
One landing light is installed in the leading edge of each wing and two landing lights are
installed on the nose radome. The taxi lights are installed outboard of the wing landing
lights, in the same wing compartments. The taxi lights also serve as recognition lights.
The nose landing lights are designed to illuminate the ground during landing and
take-off. Activation requires a gear downlock signal to prevent the lights from being on
when the landing gear is retracted.
The wing landing lights and taxi lights are high intensity discharge lamps. The landing
lights are controlled by the LEFT, RIGHT and NOSE landing light switches on the
LANDING LTS panel. The taxi lights are controlled, separately from the landing lights,
by the RECOG/TAXI LTS switch on the same panel.
The landing/taxi lights pulsing system is used to enhance the aircraft flight path
recognition quality. By pulsing alternately the intensity of the landing/taxi lights, and
illusion of exaggerated motion is created, which can be readily recognized, increasing
collision avoidance. <0031>
REV 56, Jan 31/03
Vol. 1 17--50--4
LIGHTING
External Lighting
Flight Crew Operating Manual MASTER
CSP A--013
Landing/ Taxi Lights <MST>
Figure 17---50---2
Recognition/Taxi
Lights Switch
Landing Lights
Switches
Landing/Taxi Lights Panel (1)
Overhead Panel
Recognition/Taxi Lights
Switch
LANDING / TAXI LIGHTS
WITH PULSING SYSTEM
<0031>
Landing Lights Switches
ON -- Turns on
recognition/taxi lights.
OFF -- Turns off
recognition/taxi lights.
PLS -- Turns on corresponding
landing and taxi lights
in pulsing mode.
OFF -- Turns off corresponding
landing and taxi lights.
STDY -- Turns on corresponding
landing and taxi lights in
steady mode.
ON -- Turns on
recognition/taxi lights.
OFF -- Turns off
recognition/taxi lights.
ON -- Turns on
corresponding
landing light.
OFF -- Turns off
corresponding
landing light.
Vol. 1 17--50--5
REV 56, Jan 31/03
LIGHTING
External Lighting
Flight Crew Operating Manual
CSP A--013
MASTER
External Lights Panel <MST>
Figure 17---50---3
Navigation Lights Switch
ON -- Turns on red
green and white
position lights.
OFF -- Turns off
position lights.
External Lights Panel
Overhead Panel
Strobe Lights Switch
ON -- Turns on white
anti--collision lights.
OFF -- Turns off
anti--collision lights.
Wing Inspection Switch
ON -- Turns on wing
inspection lights.
OFF -- Turns off
wing inspection lights.
Vertical Stabilizer
LOGO Light Switch <0020>
ON -- Turns on airline logo light.
OFF -- Turns off logo light.
BEACON Lights Switch <0021>
ON -- Turns on red beacon lights on
upper and lower fuselage and starts
flight data recorder.
OFF -- Turns off beacon lights.
REV 56, Jan 31/03
Vol. 1 17--50--6
LIGHTING
External Lighting
Flight Crew Operating Manual MASTER
CSP A--013
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：Bombardier_CRJ_00-Lighting(6)