曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

position, the red light in each unit flashes if the airplane is on the
ground, or if airborne the clear flashtube flashes. When the switch is
placed in the BCN position, the red flashtube in each light unit flashes
whether the airplane is on the ground or airborne.
The combined anti-collision light system, with each light unit pulsed
independently, has a flash rate of approximately 100 pulses per minute.
The system receives power from the left main bus and is protected by
the BCN/STROBE circuit breaker located within the LIGHTS group on
the pilot’s circuit breaker panel.
WING INSPECTION LIGHT
The wing inspection light system provides the copilot with a means to
visually detect ice buildup on the airplane wings during night
operations. The system consists of a WING INSP light pushbutton,
located on the LIGHTS control panel; a halogen spotlight assembly,
flush-mounted in the right side of the fuselage aft of the cockpit; and a
black spot located on the right wing leading edge. The black spot
enhances visual detection of ice accumulation; however, clear ice may
not be detectable by visual inspection alone.
Pilot’s Manual
PM-126A 4-37
The WING INSP pushbutton is a momentary action switch, meaning
that the inspection spotlight illuminates the wing area only when the
switch is held depressed. The system is powered by the right main bus
and is protected by the WING INSP circuit breaker located within the
LIGHTS group on the copilot’s circuit breaker panel.
EXTERIOR CONVENIENCE LIGHTS (OPTIONAL)
When installed, the optional convenience lighting group consists of an
area light mounted beneath each engine pylon to illuminate the
baggage compartment area on the left side of the airplane, and the
single-point pressure refueling (SPPR) access door area on the right
side of the airplane.
Selection of the baggage area light is by an additional switch mounted
inside the baggage compartment. The switch is automatically switched
OFF whenever the baggage compartment door is closed. The SPPR area
light is controlled via the SPPR panel power switch. This means that the
light will illuminate whenever power has been applied to the refueling
panel. Both area lights are powered from the hot bus system.

　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：Bombardier_Learjet-Electrical_and_Lighting(18)