曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

control panel. The system is activated when hydraulic system 3 is pressurized, the nose landing
gear is down and locked, and the PSEU “ground” mode is satisfied.
Steering control is initiated via the steering tiller and/or by the rudder pedals. Nosewheel deflection
of up to 55 degrees on either side of center is possible when using the steering tiller. Rudder pedal
movement will deflect the nosewheel up to 7 degrees either side of center.
With the NOSE STEER switch selected to ARMED, the 55-degree limit may inadvertently be
exceeded, if sufficient differential braking is applied in the direction of the turn. When the
55-degree angle is exceeded, the nosewheel steering system is automatically disabled, and the
nosewheel casters freely to a maximum of 99 degrees.
NOTE
The nosewheel steering system cannot be reengaged unless the
steering angle is less than 55 degrees, and the NOSE STEER switch is
selected to OFF and then to ARMED again.
Electronic Control Unit (ECU)
The nosewheel steering electronic control unit (ECU) controls the electrohydraulic valve that
directs hydraulic system 3 pressure to the steering actuator to turn the nosewheels. Nosewheel
position feedback is sent to the ECU from transducers mounted on the steering actuator
assembly.
In the air, the nose wheel is centered electronically by the ECU, and mechanically by centering
cams as the oleo extends.
The ECU continuously monitors the nosewheel steering system. Any faults detected are
annunciated on EICAS. Fault detection will result in steering system shutdown. When the
steering system is shut down due to a fault, or manually disarmed, nosewheel steering reverts
to the free-castering mode (which allows nosewheel deflection up to 99 degrees either side of
center), and the STEERING INOP caution EICAS message is displayed.
LANDING GEAR/BRAKES
Description
Vol. 2 15−10−12
Oct 05/06
CL−605 Flight Crew Operating Manual
PSP 605−6
NOSE WHEEL STEERING SYSTEM (CONT'D)
WARNING
ENSURE THAT THE NOSEWHEEL ASSEMBLY IS CLEAR OF
PERSONNEL AND TOWING EQUIPMENT BEFORE
SELECTING THE NOSEWHEEL STEERING SWITCH TO THE
ARMED POSITION.
Steering Tiller
Figure 15−10−7
LANDING GEAR/BRAKES
Description
Vol. 2 15−10−13
Oct 05/06
CL−605 Flight Crew Operating Manual
PSP 605−6
WHEELS AND BRAKES
Description
Dual-wheel assemblies are installed on each main landing gear strut, and each main wheel is
equipped with a carbon brake disc assembly. The nose gear has two wheels, and uses chine tires
to eject ground water away from the aircraft engines.
Components and Operation
Each wheel of the main landing gear is equipped with self-adjusting multidisc carbon brakes.
Hydraulic system 3 powers the brakes of the inboard wheels, and hydraulic system 2 powers the
brakes of the outboard wheels. A parking brake function is available at both the inboard and
outboard brakes. Anti-skid protection is provided.
Each main wheel has four fusible plugs that melt to prevent tire burst, in the event of an
overheated wheel or brake condition.
Brake application is initiated by pressing the brake pedals, which are mechanically linked to the
four associated brake control valves. The brake control valves meter hydraulic pressure to the
brakes through anti-skid control valves.
During gear retraction, hydraulic pressure from the nose landing gear is directed to the brake
control valves to stop main wheel rotation (in-flight braking).
In case of failure of hydraulic systems 2 or 3, accumulators in both hydraulic brake systems
provide pressure for approximately six brake applications with the anti-skid selected off. Loss of
either hydraulic system 2 or 3 results in a 50% reduction in braking capability. Braking remains
symmetrical, and anti-skid is available at the working brakes.
Two brake wear indicator pins are installed on each brake assembly, to provide a visual indication
of brake wear. When the end of the wear indicator pin is flush with the top of the indicator housing,
the brakes should be serviced.
NOTE
The brake wear indicator pins must be checked with the brakes
applied, and hydraulic systems 2 and 3 pressurized.
LANDING GEAR/BRAKES
Description
Vol. 2 15−10−14
Oct 05/06
CL−605 Flight Crew Operating Manual
PSP 605−6
WHEELS AND BRAKES (CONT'D)
Brakes and Lower Main Gear Structure
Figure 15−10−8
HYDRAULIC Synoptic Page (Inboard and Outboard Brake Pressure)
Figure 15−10−9
Parking Brake
To apply the parking brake, fully depress both brake pedals on the pilot’s or copilot’s side, pull
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：龐巴迪挑戰者605機組操作手冊 CL605-LANDING_GEAR(5)