Comply with the engine and aircraft certification requirements (U.S. FAR – Part 33 and FAR – Part 25, respectively, or the applicable equivalent regulation).

The engine certification (FAR – Part 33) ensures a time of 5 seconds or less to accelerate from 15 % to 95 % of the go-around thrust. 
The aircraft certification (FAR – Part 25) ensures that the thrust achieved after 8 seconds from power application (starting from flight/approach idle) allows a minimum climb gradient of 3.2 % for go-around.
 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
Figure 4
Certified Thrust Response –Typical
Go-around from Low Speed / Low Thrust

Table 1 indicates the thrust required (in % of the TOGA thrust) in order to achieve the following maneuvers:
 
Maneuvers
 % of TOGA Thrust
 
Flying a stabilized approach  (3-degree glide path / VAPP)
 20 %
 
Arresting altitude loss and achieving level flight
 30 %
 
Achieving “Positive Climb”
 > 30 %
 

Table 1
Thrust Required during GA Initiation

Figure 5 illustrates the go-around trajectories associated with flying an approach with:
Speed on the target final approach speed (VAPP) with idle thrust;

Speed below VAPP (VAPP – 10 kt) with idle thrust.

In case of go-around, the initial altitude loss and the time required for recovering  the initial altitude are increased if airspeed is lower than the final approach speed and/or if thrust is set at idle. In particular, the effect of lack of thrust (i.e. thrust at idle) is significant in terms of altitude loss.
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：Approach Techniques Aircraft Energy Management during Approach(6)