曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

200
900
800
000
AUTOMATIC FLIGHT CONTROL SYSTEM
4-24 For Training Purposes Only
Sept 04
P I LOT T R A I N I N G GU I D E
NAV Mode
Pushing the NAV button on the FCP alternately selects and clears the navigation mode
and causes the flight director to generate lateral commands to capture and track the
active navigation source (VOR, LOC, FMS).
The displayed navigation source will determine which navigation submode will be in
operation.
NAV Source Selection
The navigation source is selected using the NAV SOURCE knob on the DCP.
LOC or VOR navigation source is determined by the ground station frequency set on
the RTU.
All NAV mode annunciations appear in the lateral field of the FMA: armed modes in
white, and active/captured modes in green. Captures that are inhibited due to invalid
data are annunciated on the PFDs as a red horizontal line through the mode
annunciation.
VOR Navigation Mode
In VOR navigation mode, the flight director generates lateral steering commands to
capture and track the selected VOR radial (inbound or outbound), using the course
displayed on the active navigation source.
When the NAV button is pressed and the active navigation source is VOR1 or VOR2,
the VOR navigation mode is armed. The armed lateral mode field on both PFDs shows
a white VOR1 (or VOR2) annunciation. When the VOR mode is captured, the armed
annunciations are removed and a green VOR1 (or VOR2) annunciation is displayed in
the active lateral mode field on the PFDs.
The CRS1 and CRS2 knobs, located on the FCP, provide the means to select the
desired course on the pilot’s and copilot’s PFD HSI respectively. Pressing the PUSH
DIRECT knob within the CRS knob synchronizes the corresponding course display
and provides a “direct-to” VOR course.
VOR navigation mode is designed to permit tracking over station and allow for course
changes while tracking. When over a VOR station, the system can accept and follow a
course change of up to 90°. Dead reckoning operation (based on memorized heading)
is provided during VOR station passage. A white DR annunciation appears next to the
active VOR mode annunciation during dead reckoning operation.
When captured, VOR navigation mode is cleared automatically by selection of another
lateral mode, by changing the active NAV source, or by loss of the VOR signal. VOR
navigation mode can also be cleared by pressing the NAV button again.
AUTOMATIC FLIGHT CONTROL SYSTEM
For Training Purposes Only
Sept 04
4-25
P I LOT T R A I N I N G GU I D E
Display Control Panel
Figure 4-19
VOR Navigation Mode
Figure 4-20
P604_04_067
NAV
SOURCE
FORMAT RANGE
BRG TERR WX TFC
PUSH
X -SI DE
7000
10000
6
E
12
15
3
N
33
10
10
MSG1
MSG2
A
A
VOR1
A
DR ALTS
A
AP
VOR1
92
CRS 060
.8NM
YQB
ADF2
2500M
M.456
280
240
220
250
260
1.0
4
4
2
2
1
1
1.0
29.92 IN
P604_04_043
VOR1
Navigation
Source
10
100
200
900
800
000
AUTOMATIC FLIGHT CONTROL SYSTEM
4-26 For Training Purposes Only
Sept 04
P I LOT T R A I N I N G GU I D E
Localizer Navigation Mode
In localizer navigation mode, the flight director provides lateral steering commands to
capture and track the front course localizer from the active navigation source.
Whenever LOC navigation mode arms, a white LOC1 (or LOC2) annunciation is
displayed in the armed lateral mode field on both PFDs. When the LOC mode is
captured, the armed annunciation is removed and a green LOC1 (or LOC2) is
displayed in the active lateral mode field on both PFDs.
When captured, LOC navigation mode is cleared automatically by:
• Selection of another lateral mode,
• Changing the active NAV source, or
• Loss of localizer signal
LOC mode can also be cleared by pressing the NAV button again.
LOC Navigation Mode
Figure 4-21
7000
2000 1.0
6
E
12
15
3
N
33
10
10
MSG1
MSG2
A
A
LOC1
A
DR ALTS
A
AP
LOC1
6
CRS 059
.5NM
IUL
ADF2
2500M 4
4
2
2
1
1
M.456
200
160 T
2
140
170
180
1.0
2
100
200
900
800
000
29.92 IN
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：CL_604-AUTOMATIC_FLIGHT_CONTROL_SYSTEM(11)