曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

In the event the FMS vertical flight plan is not valid when VNAV is selected, a yellow
VNAV annunciation appears in the vertical armed field of the FMA.
VNAV mode is cleared by:
• pushing the VNAV button
• capturing an ILS glideslope
• changing the NAV SOURCE on the coupled side, or
• pushing the TOGA button
For additional information on VNAV, refer to the Collins FMS-6000 Flight
Management System Pilot’s Guide.
NOTE
AUTOMATIC FLIGHT CONTROL SYSTEM
4-50 For Training Purposes Only
Sept 04
P I LOT T R A I N I N G GU I D E
Controls and Indicators
General
The Flight Control Panel (FCP) provides the majority of controls for flight director
and autopilot operation. The Reversionary/Inhibit Panel allows selection between
AFCS 1 and 2. Both the pilot’s and copilot’s control wheel incorporates pushbuttons
for autopilot disconnect and flight director synchronization.
The PFD Flight Mode Annunciator (FMA) provides an indication of autopilot and
flight director status. The EICAS Primary and Status pages provide the system
warning, caution and status messages, respectively.
Reversionary/Inhibit Panel
Reversionary/Inhibit Panel
Figure 4-37
INHIBIT PUSH
1-RTU-2 FMS TUNE
1 2
AFCS
SEL
STBY
ATC
SEL
FMS
TUNE
INHIB
RTU 1
INHIB
RTU 2
INHIB
1 2
REVERSIONARY / INHIBIT PANEL
P604_04_052
AFCS SEL Switch
1
2
– Selects FCC pair 1A and 2A as the active FCCs
– Selects FCC pair 1B and 2B as the active FCCs
: Selection of AFCS 1 or 2 during AP/FD operation
will cause the autopilot to disengage and all lateral and
vertical flight director modes to clear.
NOTE
AUTOMATIC FLIGHT CONTROL SYSTEM
For Training Purposes Only
Sept 04
4-51
P I LOT T R A I N I N G GU I D E
Flight Control Panel (FCP) - Autopilot/Flight Director Modes
Flight Control Panel (FCP) - Autopilot/Flight Director Modes
Figure 4-38
FLC
SPEED
NAV HDG APPR
1/2 BANK
HDG
B/C
ALT
CRS1 ALT CRS2
FD VS FD
VNAV
DOWN
UP
XFR
TURB AP DISC
AP ENG
PUSH
DIRECT
IAS/MACH
PUSH
SYNC
PUSH
CANCEL
PUSH
D
IRECT
Flight Control Panel
P604_04_054
Pilot's FD Button (momentary-action)
Press:
Press:
With autopilot engaged










No effect if FD1 is the active flight director
Alternately removes or displays pilot’s FD command bars if
FD2 is the active FD
(pilot's FMA annunciations remain in view)
No effect if no FD modes are selected
Removes both pilot’s and copilot’s FD command bars and
FMA annunciations if FD1 is the active FD
Alternately removes or displays pilot’s FD command bars if
FD2 is the active FD
(pilot's FMA annunciations remain in view)
With autopilot disengaged
Copilot's FD Button (momentary-action)
Press:
Press:
With autopilot engaged
With autopilot disengaged










No effect if FD2 is the active flight director
Alternately removes or displays copilot’s FD command bars
if FD1 is the active FD
(copilot's FMA annunciations remain in view)
No effect if no FD modes are selected
Removes both pilot’s and copilot’s FD command bars and
FMA annunciations if FD2 is the active FD
Alternately removes or displays copilot’s FD command bars
if FD1 is the active FD
(copilot's FMA annunciations remain in view)
AP ENG Button (momentary-action)
Press:




Alternately engages or disengages
the autopilot
Illuminates the AP ENG button status
indicator lights when the autopilot is
engaged
AP DISC Switch
Press Down – Disengages the
autopilot and prevents further
autopilot engagement
: Color diagonal markings
are visible behind the AP DISC
switch to indicate switch
selection.
NOTE
XFR Button (momentary-action)
Press:






Selects copilot's side flight director (FD2) as the
active flight director
Illuminates the XFR button status indicator lights
when transfer mode is selected
Defaults to pilot's side flight director (FD1) at
power-up
NOTE: When engaged, the autopilot flies flight
guidance commands from the selected flight
director only.
TURB Button (momentary-action)
Press:




Alternately selects or deselects
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：CL_604-AUTOMATIC_FLIGHT_CONTROL_SYSTEM(19)