曝光臺 注意防騙 網(wǎng)曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費(fèi)者

8. The number in parentheses below an "A = NORMAL" table entry is the pmgraph number in this document that defines the
actions to be taken to perform normal processing on the received packet. If no paragraph number is referenced, the normal
processing is defined in the table entry.
9. An error condition is declad and transfer to the p7 state is possible only if the ground DTE address is known unambiguously.
Otherwise the action is to discard the packet.
10. The error procedure consists of performing the action when entering the p7 state (including sending a CLEAR WUEST packet
to the XDLP) but without sending a CLEAR REQUEST packet to the local DCE.
Annex 10 - Aeronarrtical Telecommrrnicutions
Table 5-17. GDLP (ADLP) effect on ADCE (GDCE) met states
Volume 111
711 1/96
No. 71
Packet received from GDLP (ADLP)
(see Note 2)
ADCE (GDCE) reset states (see Notes 1,4 and 5)
- AlxE (GDCE)
FLOW CONTROL GDLP (ADLP) ma REQUEST
READY RESET REQUEST to GDLP (ADLP)
dl d2 d3
RESET A =NORMAL A=DISCARD A =NORMAL
REQUEST (5.2.6.7) (5.2.6.7)
S=d2 S=dl
(forward to DCE) (do not forward)
RESET C0NI;IRMATION A=ERROR A =ERROR A =NORMAL
S=d3 S=d3 (5.2.6.7)
D=27 D=28 S=dl
(see Note 3) (see Note 3) (do not forward)
INTERRUPT See Table 5-18 A=ERROR A=DISCARD
S=d3
D=28
(see Note 3)
INTERRUPT CONFIRMATION See Table 5-18 A =ERROR A=DISCARD
S=d3
D=28
(see Note 3)
DATA or flow control packet See Table 5-19 A=ERROR A=DISCARD
S=d3
D=28
(see Note 3)
Format emor A=ERROR A =ERROR A=DISCARD
S=d3 S=d3
D=33 D=33
(see Note 3) (see Note 3)
NOTES:
1. The XDCE is not necessmly in the same state as the DTFDCE interface.
2. All packets from the peer XDLP bave been checked for duplication before evaluation as represented by this table.
3 The error procedure consists of performing the specified actions when entering the d3 state (which includes forwarding a
RESET FEQUEST packet to the peer XDLP) and sending a RESET REQUEST packet to the DCE (via the formatting
function).
4. Table entries are deflned as follows: A = action to bt taken, S = the state to be entered, D = the diagnostic code to be
used in packets generated as a result of th~sac tion, DISCARD indtcates that the received packet is to be cleared for the
XDLP buffers, and INVALID indicates that the packetlstate combination cannot occur.
5. The number in parentheses below an "A = NORMAL" table entry is the paragraph number in this document that defines
the actions to be taken to perform normal processing on the received packet If no paragraph number is referenced. the
normal processing is defined in the table entry.

 

　
中國航空網(wǎng) www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：附件10--航空電信an10_v3_1ed_amend_73(36)