曝光臺 注意防騙 網(wǎng)曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費(fèi)者

described in this section. For optional equipment limitations,
refer to Section 9, Supplements
The limitations included in this Section of the Pilot’s Operating
Handbook (POH) are approved by the Federal Aviation Administration.
This section provides operating limitations, instrument markings and
basic placards required by regulation and necessary for the safe
operation of the SR20 and its standard systems and equipment. Refer
to Section 9 of this handbook for amended operating limitations for
airplanes equipped with optional equipment. Compliance with the
operating limitations in this section and in Section 9 is required by
Federal Aviation Regulations.
Certification Status
The Cirrus SR20 is certificated under the requirements of Federal
Aviation Regulations (FAR) Part 23 as documented by FAA Type
Certificate TC A00009CH.
March 2010
2-4 Information Manual
Section 2 Cirrus Design
Limitations SR20
Figure 2-1
Airspeed Limitations
The indicated airspeeds in the following table are based upon Section
5 Airspeed Calibrations using the normal static source. When using
the alternate static source, allow for the airspeed calibration variations
between the normal and alternate static sources.
Speed KIAS KCAS Remarks
VNE 200 200 Never Exceed Speed is the speed limit
that may not be exceeded at any time.
VNO 165 165 Maximum Structural Cruising Speed is
the speed that should not be exceeded
except in smooth air, and then only with
caution.
VO
3000 Lb
2600 Lb
2300 Lb
131
122
114
131
123
115
Operating Maneuvering Speed is the
maximum speed at which full control
travel may be used. Below this speed the
airplane stalls before limit loads are
reached. Above this speed, full control
movements can damage the airplane.
VFE
50% Flaps
100% Flaps
120
100
120
101
Maximum Flap Extended Speed is the
highest speed permissible with wing
flaps extended.
VPD 135 135 Maximum Demonstrated Parachute
Deployment Speed is the maximum
speed at which parachute deployment
has been demonstrated.
Airspeed Limits
March 2010
Information Manual 2-5
Cirrus Design Section 2
SR20 Limitations
Airspeed Indicator Markings
The airspeed indicator markings are based upon Section 5 Airspeed
Calibrations using the normal static source. When using the alternate
static source, allow for the airspeed calibration variations between the
normal and alternate static sources.
Marking
Value
(KIAS)
Remarks
White
Arc
56 - 100 Full Flap Operating Range. Lower limit is the most
adverse stall speed in the landing configuration.
Upper limit is the maximum speed permissible with
flaps extended.
Green
Arc
65 - 165 Normal Operating Range. Lower limit is the
maximum weight stall at most forward C.G. with
flaps retracted. Upper limit is the maximum structural
cruising speed.
Yellow
Arc
165 - 200 Caution Range. Operations must be conducted with
caution and only in smooth air.
Red Line 200 Never exceed speed. Maximum speed for all
operations.
Figure 2-2
Airspeed Indicator Markings
March 2010
2-6 Information Manual
Section 2 Cirrus Design
Limitations SR20
Power Plant Limitations
Engine
Teledyne Continental ............................................................IO-360-ES
Power Rating ........................................................ 200 hp @ 2700 rpm
Maximum RPM.......................................................................2700 rpm
Oil:
Oil Temperature..................................... 240 F (115 C) maximum
Oil Pressure:
Minimum................................................................................ 10 psi
Maximum............................................................................. 100 psi
Approved Oils:
Engine Break-In: For first 25 hours of operation or until oil
consumption stabilizes use straight mineral oil conforming to MILL-
6082. If engine oil must be added to the factory installed oil, add
only MIL-L-6082 straight mineral oil.
After Engine Break-In: Use only oils conforming to Teledyne
Continental Specification MHS-24 (Ashless Dispersant Lubrication
Oil) or MHS-25 (Synthetic Lubrication Oil). Refer to Section 8 - Oil
Servicing. Oil viscosity range as follows:
All Temperatures ..............................................15W-50 or 20W-50
Above 40F (4C) ............................................... SAE 50 or 20W50
　
中國航空網(wǎng) www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：西銳20飛機(jī)信息手冊 SR22 AIRPLANE INFORMATION MANUAL 1148-126(5)