曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

control panel and adjusted for volume level by using the selected
receiver volume controls.
Audio Input Jack
Two audio input jacks are provided on the aft portion of the center
console. One jack is located near the convenience outlet for use by the
pilot and forward passenger, and another is located further aft by the
rear passenger ANR power jacks. These jacks can be used to plug in
personal entertainment devices such as portable radios, cassette
players, or CD players. Audio volume through these jacks is controlled
by connected individual entertainment device.
March 2010
7-76 Information Manual
Section 7 Cirrus Design
Airplane Description SR20
Emergency Locator Transmitter
The airplane is equipped with a self-contained emergency locator
transmitter (ELT). The transmitter and antenna are installed
immediately behind the aft cabin bulkhead to the right of the airplane
centerline. The main transmitter control switch, labeled ON-OFFARMED,
on the transmitter is in the armed position for normal
operations. A remote switch and indicator panel is installed
immediately below the circuit breaker panel. The transmitter unit is
mounted longitudinally in the airplane in order to detect deceleration
greater than 3.5 ft/sec. If rapid deceleration is detected, the transmitter
will repeatedly transmit VHF band audio sweeps at 121.5 Mhz and
243.0 Mhz approximately 0.5 seconds apart. The transmitter and
attached portable antenna are accessible through an access at the
base of the baggage compartment bulkhead. The ELT can be
removed from the airplane and used as a personal locating device if it
is necessary to leave the airplane after an accident. Eight dated “D”
cell alkaline batteries contained within the transmitter unit power the
ELT transmitter. The batteries must be replaced at specified intervals
based upon the date appearing on the battery (refer to SR-20 Airplane
Maintenance Manual).
ELT Remote Switch and Indicator Panel
The ELT remote switch and indicator panel located immediately below
the circuit breaker panel, provides test and monitoring functions for the
ELT. The panel contains a button labeled ON, a button labeled RESET,
and a red LED (light). The red light flashes when the ELT is
transmitting. The ON button is used to test the unit in accordance with
the maintenance manual procedures. The RESET button can be used
to cancel an inadvertent transmission. A 6-volt Lithium battery
mounted in the panel powers the LED. The battery must be replaced
at regular intervals (refer to SR20 Airplane Maintenance Manual).
In the event of an accident:
1. Verify ELT operation by noting that the ELT indicator light on the
remote panel is flashing.
2. If possible, access the unit as described below and set the ELT
main transmitter control switch ON.
March 2010
Information Manual 7-77
Cirrus Design Section 7
SR20 Airplane Description
Portable use of ELT:
3. Remove access at lower aft center of baggage compartment.
4. Disconnect fixed antenna lead from front of unit.
5. Disconnect lead from remote switch and indicator unit.
6. Loosen attach straps and remove transmitter unit and portable
antenna.
7. Attach portable antenna to antenna jack on front of unit.
8. Set main control switch to ON.
a. Hold antenna upright as much as possible.
Hour Meter
The airplane is equipped with an hour meter to record engine
operating time. The hour meter is located inside the armrest storage
compartment between the pilot and copilot seats. The hour meter
records time when BAT 1 switch is ON and the ALT 1 or ALT 2 switch is
set to ON. Power for hour meter operation is 28VDC supplied through
the 5-amp ENGINE INST circuit breaker on the Essential Bus.
March 2010
7-78 Information Manual
Section 7 Cirrus Design
Airplane Description SR20
Digital Clock
The airplane is equipped with a 2¼” Davtron M803 digital clock
located on the left instrument panel immediately outboard of the
airspeed indicator. The clock provides Universal Time (UT), Local
Time (LT), Elapsed Time (ET), Outside Air Temperature (OAT) in C or
F, and Voltmeter functions. All features and functions are selectable
from control buttons on the clock face. The clock receives the OAT
signal from a temperature sensor installed immediately forward of the
pilots door. The clock operates on 28 VDC supplied through the 5-amp
Engine Inst circuit breaker on Main Bus 1. Keep-alive power is
supplied through a 5-amp fuse connected to the airplane main
distribution bus in the Master Control Unit (MCU). A replaceable AA
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：西銳20飛機信息手冊 SR22 AIRPLANE INFORMATION MANUAL 1148-126(76)