曝光臺 注意防騙
網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者
drive train system instruments. The RED markings on the
dials of these instruments indicate the limit above or below
which continued operation is likely to cause damage
or shortened life, white background may be utilized to
highlight RED markings. The GREEN markings on instruments
indicate safe or normal range of operation.
The YELLOW markings on instruments indicate the time
limited range or when special attention should be given
to the operation covered by the instrument. Operation is
permissible in the yellow range, but should be avoided.
BLUE is a maximum indication associated with sustained
operation of the related aircraft system for a prescribed
period of time. Limitations (fig. 5-2-1) which are marked
on the various instruments are not necessarily repeated
in the subsequent text. When further explanation of certain
markings is required, refer to the specific area of
discussion.
5-2-3. Instrument Glass Alignment.
All instruments with range markings on the glass have
short white alignment marks extending from the dial
glass onto the rim of the indicator. These slippage marks
appear as a single line when limitation markings on the
glass properly align with the proper increments on the
dial face. However, the slippage marks appear as separate
radial lines when a dial glass has rotated
5-2-4. Rotor Limitations.
Refer to figure 5-2-1 for limitations. Should 108 percent
power off be inadvertently exceeded, no entry need be
made in DA Form 2408-13-1 unless the rotor system
accelerates to 111 percent or above. Even though no
action is required when RPM exceed 108 percent power
off but remains less than 111 percent, willful operation
should not be conducted in this range. Operation between
96 and 92 percent is permitted when water taxiing.
5-2-5. Inoperative Cruise Guide Indicator.
Flight at or below 98 percent RRPM with an inoperative
cruise guide indicator is prohibited.
5-2-6. Starting and Shutdown Limits.
The APU shall not be started with a tailwind in excess of
25 knots. Main engines shall not be started with a tailwind
in excess of 10 knots. The rotor blade start-up and shutdown
limits of figure 5-7-1 shall be observed. if it becomes
necessary to shut down in conditions outside the
limits shown in figure 5-7-1, the following precautions are
recommended:
a. Aircraft should be landed in an area which is
clear, as level as possible, and at least 300 feet away
from any vertical obstructions, abrupt changes in ground
terrain, trees, bushes, fences, etc.
b. Aircraft should be oriented such that the wind
would be coming in at the left side. If the pilot is unsure
of the wind direction after landing, a crew member should
be dispatched beyond the rotorwash to make a true wind
direction determination before engines are secured.
TM 1-1520-240-10
5-2-2
111
115 PERCENT DISREAGRD (NOT APPLICABLE)
Figure 5-2-1. Instrument Markings (Sheet 1 of 5)
TM 1-1520-240-10
5-2-3
400O C
810
890
781
940
890
O
O
O
O
O
C
C
C
C
C
Figure 5-2-1 Instrument Markings (Sheet 2 of 5)
TM 1-1520-240-10
5-2-4
RED 5 PSI MINIMUM PRESSURE AT GROUND IDLE (50% N1)
35 PSI MINIMUM AT 80 TO 95% N1
50 PSI MINIMUM AT 95% N1 OR ABOVE
GREEN 35-90 PSIG MINIMUM NORMAL OPERATING PRESSURE RANGE
RED 150 PSIG MAXIMUM PRESSURE FOR COLD
RED 110 PSIG MAXIMUM PRESSURE FOR CONTINGENCY POWER
Figure 5-2-1 Instrument Markings (Sheet 3 of 5)
TM 1-1520-240-10
5-2-5
Figure 5-2-1 Instrument Markings (Sheet 4 of 5)
TM 1-1520-240-10
5-2-6
GREEN
BLUE
YELLOW
RED
Figure 5-2-1 Instrument Markings (Sheet 5 of 5)
TM 1-1520-240-10
5-3-1/(5-3-2 blank)
SECTION III. POWER LIMITS
5-3-1. Engine Rating and Power Level Limits.
For variations in torque available with temperature and
pressure altitude, refer to the Torque Available charts in
Chapter 7.
5-3-2. 712 Emergency Power.
Emergency power is only to be used during actual emergency
conditions. After 30 minutes of emergency power
time have accumulated, the engine must be inspected
5-3-3. 714A Contingency Power.
Usage of contingency power 900to 930C PTIT is permissible
for an unlimited number of occurrences as long
as each occurrence is 2 minutes 30 seconds or less.
Maximum transient 940C PTIT is not to exceed 12 seconds.
5-3-4. 712 Engine Limitations.
See figure 5-2-1 for limitations. A gas producer (N1)
overspeed exists when an N1 of 110 percent is exceeded.
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：
支奴干運輸直升機操作手冊1(146)
