曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

d. Current net assignments.
4. LOAD MISSION (1, 2, 3) keys  Press as
required to load mission data 1, 2, or 3.
e. Authentication subscriber data.
d. DTS Mission Storing.
15. For weapons:
NOTE
a. Gun rounds count.
• Ensure that an operational battery is
b. ATAS uncage mode. installed in the data cartridge before
installation in the aircraft. If no internal
c. HELLFIRE primary/alternate laser code. battery power is available, the mission
store function of aircraft data to the data
cartridge cannot be accomplished. No
d. HELLFIRE missiles per code. “DTS FAIL” message will be displayed
under these conditions.
e. Rocket types per zone. • STORE FAIL will display if data storing is
unsuccessful.
f. Rocket fuze/cue distances (airburst and
contact).
1. STORE DATA IN MISSION 1, 2, or 3 keys 
a. DTS Description. The DTS consists of a ground Press as required to store mission data.
station, a data transfer cartridge (DTC), and data
transfer receptacle (DTR) in the helicopter. Power is 2. STORE key  Press.
provided by 28 Vdc essential bus and circuit protection
is provided by DATA XFER circuit breaker located on 3. MFK  Enter required identifier for selected
the center post circuit breaker panel. stored data keys.
b. DTS Controls and Functions. The system is
controlled by MFD keys and monitored through the 4-36. DATA TRANSFER SYSTEM.
CDS interface. See fig. 4-22 for controls and functions. The Data Transfer System (DTS) enables crew to
rapidly load CDS with required mission data prior to
c. DTS Mission Loading. flight. The DTS can program CDS memory with the
following:
NOTE
1. Aircrew checklist.
Data may be loaded and stored while on the
ground or in flight, although weapons data 2. Initial position coordinates.
and i n i t i a l position data w i l l not be
transferred during an in-flight load. 3. 30 Waypoints, 30 targets, 10 TACAN stations
with elevation, magnetic variation, and
1. INIT PAGE 1 key  Press. INITIAL PAGE 1 navigation frequency or channel TACAN
displays. mode, channel and ID.
2. INIT PAGE 2 key  Press. INITIAL PAGE 2 4. Flight plan of up to 20 waypoints.
displays.
5. Battlefield graphics list of up to 40 waypoints.
3. DATA LOADER TRANSFER key  Press. DL
TRANSFER page displays. 6. Prepoint List.
4-46
TM 1-1520-248-10
7. For each FM radio: a. Gun rounds count.
a. Manual channel frequency. b. ATAS uncage mode.
b. Cue channel frequency and ID (SINCGARS c. HELLFIRE primary/alternate laser code.
only). For 17 presets, frequency and ID
(shared between FM-1 and FM-2). d. HELLFIRE missiles per code.
c. Radio mode. e. Rocket types per zone.
8. For the UHF radio: f. Rocket fuze/cue distances (airburst and
contact).
a. Manual channel frequency and ID. For 17
presets, frequency, and ID. a. DTS Description. The DTS consists of a ground
station, a data transfer module (DTM), and data
b. Radio mode. receptacle unit (DRU) in the helicopter. (The
combination of the DRU, with the DTM plugged in to it,
c. Up to six WODs, including dates (for HQII). is also referred to as the Map Data Unit (MDU).) Power
is provided by 28 Vdc essential bus and circuit
9. For the VHF radio: protection is provided by DATA XFER circuit breaker
located on the aft overhead console panel.
a. Manual channel frequency.
b. DTS (MDU) Controls and Functions. The DTS
b. For 17 presets, frequency, and ID. (MDU) is controlled by MFD keys and monitored
through the CDS interface. See fig. 4-22 for controls
10. For the HF radio: and functions.
a. XMIT manual frequency. c. DTS (MDU) Mission Loading.
b. XMIT frequency for channels 1-9. NOTE
c. RECV manual frequency. • Data may be loaded and stored while on
d. RECV frequency for channels 1-9. the ground or in flight, although weapons
data and initial position data will not be
e. Selective addresses for all channels. transferred during an in-flight load.
f. Radio mode. • RMS map data stored in the DTS (MDU)
is available to the CDS for operation of
g. Scan list. the RMS but is not downloaded to the
aircraft.
11. IFF modes and 3/A code.
1. INIT button  Press. INITIAL PAGE 1
12. The pilot may at any time store all current displays.
mission data into one of the three storage
locations in the MDU. 2. INIT PAGE 2 key  Press. INITIAL PAGE 2
displays.
13. Laser codes A through H.
3. DATA LOADER TRANSFER key  Press. DL
14. For IDM: TRANSFER page displays.
a. Net definitions for eight nets. NOTE
b. Subscriber lists for each net. A boxed LOAD FAIL will display in the
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：TECHNICAL MANUAL OPERATOR’S MANUAL FOR ARMY OH-58D HELICOPT(105)