6.  
Divides attention between gyroplane control and orientation.

7.  
Exits at the point of entry.

8.  
Maintains the entry altitude throughout the maneuver, –100 feet (30 meters) and airspeed, –10 knots.

C. TASK: TURNS AROUND A POINT
REFERENCE: AC 61-21.
Objective. To determine that the applicant:
1.  
Exhibits knowledge of the elements related to turns around a point.

2.  
Selects an appropriate reference point based on wind direction and emergency landing areas.

3.  
Plans the maneuver to enter at traffic pattern altitude, at an appropriate distance from the reference point, with the gyroplane headed downwind.

4.  
Tracks a constant radius circle around the selected reference point with a bank of approximately 40° at the steepest point in the turn.

5.  
Divides attention between gyroplane control and orientation.

6.  
Exits at the point of entry.

7.  
Maintains the entry altitude throughout the maneuver, –100 feet (30 meters) and airspeed, –10 knots.

VII. AREA OF OPERATION: NAVIGATION
A. TASK: PILOTAGE AND DEAD RECKONING
REFERENCES: AC 61-21, AC 61-23, AC 61-84.
Objective. To determine that the applicant:
1.  Exhibits knowledge of the elements related to pilotage and dead reckoning.
2. Correctly flies to at least the first planned checkpoint to demonstrate accuracy in computations.
3.  
Identifies and follows landmarks by relating the surface features to chart symbols.

4.  
Navigates by means of precomputed headings, groundspeed, and elapsed time.

5.  
Verifies the gyroplane’s position within 3 nautical miles (5.6 Km) of the flight planned route at all times.

6.  
Arrives at the en route checkpoints within 5 minutes of the ETA.

7.  
Maintains the appropriate altitude, –200 feet (60 meters) and established heading, –15°.

B. TASK: RADIO NAVIGATION AND RADAR SERVICES
REFERENCES: AC 61-21, AC 61-23, AC 61-84; Navigation Equipment Operation Manuals.
NOTE: If the gyroplane is not equipped with radio navigation aids, competency will be evaluated through oral testing.
Objective. To determine that the applicant:
1.  
Exhibits knowledge of the elements related to radio navigation and ATC radar services.

2.  
Selects and identifies the appropriate facilities or coordinates, as appropriate.

3.  
Locates the gyroplane's position relative to the navigation facilities or coordinates, as appropriate.

4.  
Intercepts and tracks a given radial or bearing.

5.
Locates position using cross radials, coordinates, or

bearings.

6.  
Recognizes and describes the indication of station or way

point passage. 7 Recognizes signal loss and takes appropriate action.
8.  
Uses proper communication procedures when utilizing ATC radar services.

9.  
Maintains the appropriate altitude, –200 feet (60 meters).

C. TASK: DIVERSION
REFERENCES: AC 61-21, AC 61-23, AC 61-84.
Objective. To determine that the applicant:
1.  
Exhibits knowledge of the elements related to procedures for diversion.

2.  
Selects an appropriate alternate airport and route.

3.  
Promptly diverts toward the alternate airport.

4.  
Makes an accurate estimate of heading, groundspeed, arrival time, and fuel consumption to the alternate airport.

5.  
Maintains the appropriate altitude, –200 feet (60 meters) and established heading, –15°.

D. TASK: LOST PROCEDURES
REFERENCES: AC 61-21, AC 61-23, AC 61-84; AIM.
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：PRIVATE PILOT Practical Test Standards for ROTORCRAFT HELICO(28)