曝光臺 注意防騙 網(wǎng)曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

9  Visual inspection of the windshield and canopy (check for cracks, scratches, glazing, matting).  X  X  X 
10  Inspection of canopy mechanisms (check their operation, greasing).  X  X  X 
11  Visual inspection of seats, upholstery and seat belts (check their adjusting, fastening, check for damages).  X  X  X 
12  Visual control of fabric skinned control surfaces (check for pricks and cuts).  X  X  X 
13  Removal of control surfaces, checking for wears at hinges and bolts, and replacing any worn out elements.  X 
2.5.3. Aircraft equipment (see fig. 2; 8; 9) 
1  Visual inspection of control panel (check the fastening of instruments and tags, the wiring).  X  X  X 
2  Visual inspection of pipes and cables in the airplane and engine compartment (check the integrity, secure fastening, condition of protection elements, cleanliness of fuel and air filters, fuel system ventilation).  X  X  X 
3  Check the cleanliness of the finger filter located in the fuel tank flange and the settling filter screening element flange; replace the fine filter  X  X 
4  Check the fluid level in the systems; check for any leakage (oil, cooling fluid, brake fluid)  X  X  X 
5  Visual inspection of the battery  X  X  X 

S.C. AEROSTAR  S.A.
FESTIVAL R40S
BACAU - ROMANIA
   AIRPLANE MAINTENANCE MANUAL
installation. 
6  Engine mount (check its fastening, check for cracks, verify the technical condition of the shock absorbers).  X  X  X 
7  Compass compensation  X  or 1000 hours 
8  Checking of rubber elements, replacing any worn out parts.  X 
9  Inspection of cooling pipe sleeves and coolant expansion tanks  X  X  X 
10  Propeller: inspection, reconditioning.  X  X  X 
11  Checking of instruments at the electrical workshop.  X 
12  Replacing of oil  X  X  X 
13  Inspection of oil pressure and temperature probes  X  X  X 
14  Checking the brake cylinder fastening at the rudder pedals  X  X 
15  Checking the brake disk wear  X 
16  Checking the wear of brake pads in brake lining.  X  X 

2.5.4. Flight controls (see fig. 6; 11; 12; 23; 27) 
1  Visual inspection of cables, rolls, guides, checking their greasing.  X  X  X 
2  Visual inspection of the control stick axle (check for damages, check the condition of the bearings, the fastening of the control sticks).  X  X  X 
3  Visual inspection of elevator trim tab and trim tab control (checking their greasing).  X  X  X 
　
中國航空網(wǎng) www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：FESTIVAL R 40S AIRPLANE MAINTENANCE MANUAL(20)