曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

(CAS) for level flight, climb, and autorotation.
7-11-2. Use of Chart.
The primary use of the chart is illustrated by example. To
determine calibrated airspeed, it is necessary to know
IAS and flight regime. Enter chart at indicated airspeed,
move right to appropriate flight regime, move down and
read calibrated airspeed.
7-11-3. Conditions.
Presented airspeed calibration charts are for CH-47D
helicopters with T55-L-712 engines.
TM 1-1520-240-10
7-11-2
Figure 7-11-1. Airspeed Calibration Chart
TM 1-1520-240-10
7A-1-1
CHAPTER 7A
714A PERFORMANCE DATA
SECTION I. INTRODUCTION
7A-1-1. Purpose.
The purpose of this chapter is to provide the best available
performance data for the CH-47D helicopter. Regular
use of this information will enable you to receive maximum
safe utilization from the aircraft. Although
maximum performance is not always required, regular
use of this chapter is recommended for the following
reasons.
a. Knowledge of your performance margin will allow
you to make better decisions when unexpected conditions
or alternate missions are encountered
b. Situations requiring maximum performance will
be more readily recognized.
c. Familiarity with the data will allow performance to
be computed more easily and quickly
d. Experience will be gained in accurately estimating
the effects of variables for which data are not presented.
7A-1-2. General Data.
The data presented covers the maximum range of conditions
and performance that can reasonably be expected.
In each area of performance, the effects of altitude, temperature,
gross weight (GW), and other parameters relating
to that phase of flight are presented. In addition to
the presented data, your judgement and experience will
be necessary to accurately obtain performance under a
given set of circumstances. The conditions for the data
are listed under the title of each chart. The effects of
different conditions are discussed in the text accompanying
each phase of performance. Where practical, data is
presented at conservative conditions. However, NO
GENERAL CONSERVATISM HAS BEEN APPLIED. All
performance data presented is within the applicable limits
of the aircraft.
CAUTION
Exceeding operating limits can cause permanent
damage to critical components.
Over limit operation can decrease performance,
cause immediate failure,or failure
on a subsequent flight.
7A-1-3. Limits.
Applicable limit lines are shown on the charts. The
dashed lines on the cruise charts are estimated airspeed
limits with an operating cruise guide indicator (CGI).
Airspeed limits with the CGI inoperative are in Chapter
5.If limits are exceeded, minimize the degree and time.
7A-1-4. Use of Charts.
a. Chart Explanation. The first page of each section
describes the chart(s) and explains its use.
b. The primary use of each chart is given in an example
and a guideline is provided to help you follow the
route through the chart. The use of a straight edge (ruler
or page edge) and a hard fine point pencil is recommended
to avoid cumulative errors. The majority of the
charts provide a standard pattern for use as follows:
enter first variable on the top left scale, move right to the
second variable, deflect down at right angles to the third
variable, deflect left at right angles to the fourth variable,
deflect down, etc. until the final variable is read out at the
final scale. In addition to the primary use, other uses of
each chart are explained in the text accompanying each
set of performance charts.
NOTE
An example of an auxiliary use of the charts
referenced above is as follows: Although the
hover chart is primarily arranged to find
torque required to hover, by entering torque
available as torque required, maximum wheel
height for hover can also be found. In general,
any single variable can be found if all others
are known. Also, the tradeoffs between variables
can be found. For example, at a given
pressure altitude (PA), you can find the maximum
GW capability as free air temperature
(FAT) changes.
c. Dashed Line Data. Data beyond conditions for
which tests were conducted, or for which estimates are
used, are shown as dashed lines.
7A-1-5. Data Basis.
The type of data used is indicated at the bottom of each
performance chart under DATA BASIS. The applicable
report and date of the data are also given. The data
provided generally is based on one of the following categories.
a. Flight Test Data. Data obtained by flight test of
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：支奴干運輸直升機操作手冊2(14)