Eaglesoft Development Group: Citation II SP/2 C551 Operating Manual
1
Cessna/Citation II
C551 SP/2
Operating Manual
by
Eaglesoft Development Group
Bill Leaming & Bob Hayes
Ron Hamilton, President
Eaglesoft Development Group: Citation II SP/2 C551 Operating Manual
2
Introduction
Thank you for your purchase of the Eaglesoft Citation II SP/2. We hope you enjoy flying her as much as we
have enjoyed building this aircraft. The Citation II SP/2 is also known as the Model C-551, which is a singlepilot
certified, twin engine business jet. Our model represents a recently refurbished, 1985 aircraft, which has
already provided a long service life.
This “Introduction” chapter will introduce the 2d panel, mousepoints, and discuss briefly the major instruments.
Detailed information on instrumentation will be covered in Chapter Two: Operating Manual, and Chapter
Three: EHSI. Chapter Four will cover Specifications, Operating Limitations, and Weight & Balance.
Main Panel:
This is a view of the main 2d panel, after the Master Battery and Avionics have been turned on. There are three
“hotspots” on the 2d panel, described as follows:
1) Toggles on/off a zoomed view of the Engine/Electrical subpanels.
2) Toggles on/off a view of the Course and Heading subpanel, which is normally found on the center throttle
console.
3) Toggles on/off the Simicons, which themselves will open/close various subpanels and popups.
1
2
3
Eaglesoft Development Group: Citation II SP/2 C551 Operating Manual
3
Introduction
Main Panel:
In the picture above, all three of the “hotspots” have been activated, so you can see the zoomed view of the
Engine/Electrical subpanel, the AP/YD Master + Pitch + Rudder (Yaw) electrical trim controls, and finally, the
Simicons subpanel.
Please take note that every switch, knob and button on this panel features “custom tooltips,” which will clearly
identify the control by name, and in the case of many, will provide a “digital readout” of the value (such as Airspeed,
Airspeed Bug, Altimeter Kohlsman setting [both inHg and MB], Heading, Course, etc.), so even though
the text on the panel is small, there is no reason for despair! It was decided that our dedication to producing an
authentic, true-to-scale representation of the actual aircraft’s panel was something we weren’t willing to abandon,
so I’ve taken great pains to make sure that every control is easily identifiable. Once you’ve become accustomed
to the panel, you might wish to switch off the “custom tooltips” via the FS Options menu. It is your
choice!
Eaglesoft Development Group: Citation II SP/2 C551 Operating Manual
4
Introduction
Main Panel:
Display/Hide Engine/Electrical subpanel
Display/Hide Pressurization subpanel
Display/Hide Throttle Quadrant
Display/Hide ADI & EHSI “Zoomed View”
Display/Hide GPS*
Display/Hide Engine/Electrical subpanel
Display/Hide Kneeboard/Checklist*
Display/Hide ATC Menu*
Display/Hide Map*
Display/Hide Audio Controls subpanel
NOTE: Asterisked Items are MSFS defaults
Getting Started Quickly:
The following procedure is not an official checklist, but rather is written so that the interminably anxious can
get the aircraft model started quickly and simply for their initial “test flight!” :)
1) Click on the X to open the Simicons subpanel, and click on the E-Arrow button to open the Eng/Elec panel.
2) Click on the “Airplane” button to open the Throttle Quad subpanel.
3) Turn on Master Battery and Avionics switches.
4) Make sure the Parking Brake is set (Ctrl-period).
5) Turn on the Right Ignition switch, and then click on the Right Engine Start (round yellow button).
6) As the engine spools up, click TWICE just below the Right Power Lever to switch ON the fuel valves. The
knob will move UP to the Idle detent. (Note: if you have a CH Yoke or other “mixture control”, make
sure it is fully forward!)
7) After the Right engine is started, switch OFF the R Ignition switch, and turn ON the L Ignition switch.
8) Press the yellow L engine Starter button, and click TWICE just below the Left Power Lever to open fuel
flow, just as you did before.
9) Switch OFF the L Ignition switch, and turn ON L & R Alternators and the Inverter Switch.
10) Close the Eng/Elec & Throttle Quad subpanels, by click on the appropriate Simicons, and Open the Pressurization
subpanel.
11) Use the “Cruise Altitude” knob to preset
your planned cruise altitude on the dial.
12) Set “Pressure Source” knob to
中國(guó)航空網(wǎng) www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：Citation II SP/2 C551 Operating Manual
