曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

limited leadtime and cost, with the minimum of provisions installed in the Basic
Build Status.
Flexible Zones Industrialization/Aircraft Build
Definition
For A340/A330 these are Pre-Defined and Pre-Designed areas where
provisions have been made during the definition of the Structure/Systems to
accept different Locations/Technical Solutions.
Approved Terms © Airbus SAS 2007. All rights reserved. Confidential and proprietary document.
31/79
19 Mar 07
Term Domain Definition Source
Lexinet - Airbus Reference Language
Approved Terms
Flight Aircraft Operation/Operations
Engineering
The entire passage consisting of one or more flight legs, from leaving the
airport of origin to arrival at the airport of final destination and operated under
one flight number.
WATOG
Flight Crew Operating
Manual
Aircraft Operation/General The FCOM is the basic reference document for flight crews and flight operation
engineering. FCOM provides aircraft systems descriptions, flight procedures
and performance.
Flight Crew Report Flight Test/Activity Document established by the Flight Test Engineer and/or the Pilot in command,
who then countersigns, which gives the results and crew comments of a test
flight. A FCR is mandatory for every test flight.
A copy is submitted to the Airworthiness Authorities.
Flight Cycle Aircraft Operation/Operations
Engineering
A completed takeoff and landing sequence.
Flight Hours Aircraft Operation/Operations
Engineering
For Airbus, this is airborne time, i.e. wheels-off to wheels-on.
Notes: 1)Term also used (but not by Airbus) for block hours. Ref. WATOG
(TIME, FLIGHT) which gives the following definition: "Either: (a) Airborne time,
i.e. wheels-off to wheels-on ; or (b) block time, i.e. chocks-away to chocksunder.
2) FAA Regulations (FAR 1.1) define flight time as block time whereas
European regulations (JAR 1.1) define flight time as airborne time. When the
term "Flight time" is used, or values of flight time are quoted, the definition
which applies shall be stated".
Flight Level Aircraft Operation/Flight
Operations
A level of constant atmospheric pressure related to the standard atmosphere.
For convenience these are referred to in numbers which represent hundreds of
feet. For example, Flight Level 250 represents a barometric altimeter indication
of 25 000 feet.
Flight Manual Aircraft Operation/General The FM gives the limitations, the procedures and the performance required by
the aircraft type certifications.
The FM is approved by the airworthiness Authorities.
Flight Operations Desk Flight Test/Activity Responsible for the support required for all test flights: Air Traffic Control
clearances, Flight Planning, Ground control around St Martin test facilities, flight
crew allocation, aircraft documentation...
Approved Terms © Airbus SAS 2007. All rights reserved. Confidential and proprietary document.
32/79
19 Mar 07
Term Domain Definition Source
Lexinet - Airbus Reference Language
Approved Terms
Flight Order Flight Test/Activity Document established by the Flight Test Engineer responsible for the test flight
and countersigned by the Pilot in command. It defines the tests to be performed
during a flight and includes test procedures, A/C applicable limitations and
safety procedures. The Flight Order is a legal document which is transmitted to
the Airworthiness Authorities and which must be duly signed prior to the flight. A
copy of the Flight Order remains on ground while the aircraft is in flight.
Flight Plan Aircraft Operation/Flight
Operations
Specified information relating to the intended flight of an aircraft that is filed
orally or in writing with an Air Traffic Control (ATC) facility.
Flight Plan Computation
Program
Aircraft Operation/Performance
Engineering
The FLIP permits the computation of complete flight profiles. The FLIP works
from the High Speed (HSP) data base.
A300B/A310/A300-600/A320
Flight Test Analysis Flight Test/Activity Software system used to manage all flight test activity, eg: programs, A/C
activity.
Flight Test Installation Aircraft Operation/Flight
Operations
All the equipment fitted to an aircraft for in-flight test measurements.
Flight Test Management
System
Flight Test/Activity Replaced by FTA, Flight Test Analysis.
Flight to Hamburg Planning Date indicated in production programs. It generally coincides with the start of
the interior furnishing phase done by Airbus Deutschland GmbH at Hamburg.
Flight to Toulouse Planning Date indicated in production programs. It generally coincides with the end of the
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：空客縮略語Airbus Reference Language Abbreviations (Approved(61)