曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

BUS 2
AC
ESS BUS
ELECTRICAL
7-4 For Training Purposes Only
May 03
P I LOT T R A I N I N G GU I D E
Components and Operation
Integrated Drive Generators (IDGs)
Two engine-driven IDGs supply 115-volt AC, 400-Hz, three-phase electrical power to
the AC buses. The IDG consists of two subcomponents, a constant speed drive and an
electrical generator.
The generators are identified on the EICAS AC Electrical Synoptic page by the
symbols GEN 1 and GEN 2 (see Figure 7-4). The nominal rating of each generator is
30 kilovolt-amperes (kVA) to an altitude of 35,000 feet MSL, then 25 kVA to 41,000
feet MSL. In the event of a single generator failure, the remaining generator is capable
of supplying sufficient power for operation of the main systems.
The generators are controlled by two-position GEN 1 or GEN 2 switches located on
the ELECTRICAL POWER Panel. Selecting GEN 1 or GEN 2 switch to ON connects
the respective generator to the main AC buses provided they are operating normally.
Selecting the switches to OFF/RESET will disconnect the respective generator from
the main AC buses. The OFF/RESET position can also be used to reset the generator
control circuit when a fault occurs.
Generator Control Unit
Each IDG is controlled and monitored by its respective generator control unit (GCU).
The GCUs provide protection and bus priority logic during normal and non-normal
operations. The engine generator is tripped off and removed from the AC buses if any
of the following conditions occur:
• over- and undervoltage
• over- and underfrequency
• generator and bus overcurrent
ELECTRICAL
For Training Purposes Only
May 03
7-5
P I LOT T R A I N I N G GU I D E
GEN 1 and GEN 2 Power
Figure 7-4
AC ELECTRICAL
UTIL BUS 1
BUS 2
GEN
2
GEN
1
APU
BUS 1
UTIL BUS 2
GEN
ESS BUS
P604_07_028
4
115
400
KVA
V
HZ
4
115
400
KVA
V
HZ
0
0
0
KVA
V
HZ
ELECTRICAL POWER
BATT MASTER EXT. POWER
APU GEN GEN 2
OFF/
RESET
OFF/
RESET
ON
ON
OFF
ESS. POWER DC POWER
AC ESS XFER MAIN BUS TIE
AC POWER
GEN 1
OFF/
RESET
AVAIL
IN USE
IN
USE
ON
AUTOXFER
FAIL
OFF
FAIL
OFF
ALTN CLOSED
ON
AC DC
ELECTRICAL
7-6 For Training Purposes Only
May 03
P I LOT T R A I N I N G GU I D E
APU Generator
The APU generator supplies 115-volt AC, 400-Hz, three-phase electrical power to the
AC buses during ground operations with the engines off. The APU generator may also
be used in flight as a backup power source to the AC buses following a failure of both
engine generators. The APU generator is mounted on the APU generator adapter and
is driven at a constant speed, maintaining its frequency output at 400 Hz.
The APU generator is identified on the AC Electrical Synoptic page by the symbol
GEN above the APU icon (see Figure 7-5). The nominal rating of the APU generator
is 30 kVA from sea level up to the APU’s maximum operating altitude of 20,000 feet
MSL.
The two-position APU GEN switch located on the ELECTRICAL POWER Panel
controls the APU generator. Selecting the APU GEN switch to ON connects the APU
generator to the main AC buses, providing it is operating normally. Selecting the
switch to OFF/RESET disconnects the APU generator from the main AC buses. The
OFF/RESET position can also be used to reset the generator control circuit when a
fault occurs.
Use of the APU generator in flight is not permitted unless both
main generators have failed or are off-line.
Generator Control Unit
The APU generator is controlled and monitored by the APU generator control unit
(GCU). The APU GCU in conjunction with the engine GCUs provide protection and
bus priority logic during normal and non-normal operations. The APU GENERATOR
is tripped off and removed from the AC buses if any of the following conditions occur:
• over- and undervoltage
• over- and underfrequency
• generator and bus overcurrent
NOTE
ELECTRICAL
For Training Purposes Only
May 03
7-7
P I LOT T R A I N I N G GU I D E
APU Power
Figure 7-5
P604_07_029
AC ELECTRICAL
UTIL BUS 1
BUS 2
GEN
2
GEN
1
APU
BUS 1
UTIL BUS 2
0
0
0
GEN
ESS BUS
KVA
V
HZ
0
0
0
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：龐巴迪挑戰者手冊1(22)