曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

KCA-727-20 29069-002 10-60707-11
CA-27-20C 28111-004 10-60707-15
CA-727-20CR 25582-006 10-60707-16
KCA-727-20CR 29069-004 10-60707-17
CA-727-20 25582-003 10-60707-10
CA-727-20CR 25582-006 10-60707-16
MarathonNorco Aerospace, Inc.
OPERATING and MAINTENANCE MANUAL
NICKEL-CADMIUM AIRCRAFT BATTERIES
24-34-00 Page 702
APR 15/06
Table 7
CAPACITY TEST AMPERES
Cell Type “C” Rate C/2 Rate
3H120 3 1.5
5H120 5 2.5
10H120 10 5.0
12M220 12 6.0
12H120 12 6.0
14M220 14 7.0
15M220 13 6.5
17H100 17 8.5
17SP100 17 8.5
18H120 17 8.5
20SPE100 20 10.0
20H120 20 10.0
24M220CR 24 12.0
24ME220 24 12.0
24H120 24 12.0
24SP100 24 12.0
28SP100 28 14.0
36H120 40 20.0
38H100 38 19.0
38SP100 38 19.0
40SP100 40 20.0
40SP100L 40 20.0
44SP100 44 22.0
44SP100L 44 22.0
46SPE100 46 23.0
52H120C 52 26.0
65H120 60 30.0
81H120 80 40.0
MarathonNorco Aerospace, Inc.
OPERATING and MAINTENANCE MANUAL
NICKEL-CADMIUM AIRCRAFT BATTERIES
24-34-00 Page 801
APR 15/06
8.0 RECONDITIONING
When reconditioning is required discharge the battery until cells reach 0.5 volts or less. Place a short-out
clip across each cell once it has reached 0.5 volts or less.
When all cells have a short-out clip attached, turn off discharge unit.
Allow battery to stand in a shorted condition for a minimum of 4 hours, preferably overnight.
Remove short-out clips and return to Paragraphs 5.0, Step 1A.
− A severely unbalanced battery may need to be deep cycled as many as three times to restore its
capacity.
− If after three (3) deep cycles some cells still have not had their capacity restored, these cells
should be replaced.
− If five (5) or more cells are found to be defective, either at one time or over a period of time, it is
recommended that all cells be replaced.
MarathonNorco Aerospace, Inc.
OPERATING and MAINTENANCE MANUAL
NICKEL-CADMIUM AIRCRAFT BATTERIES
24-34-00 Page 901
APR 15/06
9.0 CLEANING
CAUTION: Exercise extreme care when working around the battery. Do not use metal
brushes or metal brush supports. Remove rings and other metal jewelry from the
hands. Any of these may cause an electrical short which may result in skin burns
and damage to the battery.
The battery should be kept in a clean, dry state for optimum performance. The extent of the cleaning
process depends upon the condition of the battery. Several procedures are described in the following
paragraphs.
If heavy overcharging has occurred, gassing and spewing of electrolyte may cause a white powdery
substance, potassium carbonate, to form on top of the cells. This may be removed by brushing the cells
with a non-conductive stiff bristle brush or a clean cloth.
If necessary, the tops of the cells may be flushed with ordinary tap water (of low mineral content). Make
certain that all of the cell vent plugs are properly seated. Tip the battery at about a 45° angle with its
receptacle (or power connector) facing upward. Flush with water from the top of the battery in a
downward direction so as to prevent, as much as possible, any water from entering the battery can. It is
permissible to use a non-conductive bristle brush to clean away stubborn dirt particles. Any excess liquid
should be drained off and the battery permitted to dry. Drying may be accelerated by the use of oil-free
compressed air.
WARNING: USE OF COMPRESSED AIR FOR CLEANING CAN CREATE AN ENVIRONMENT OF
PROPELLED FOREIGN PARTICLES WHICH MAY ENTER THE EYES AND CAUSE SERIOUS
INJURY. AIR PRESSURE FOR CLEANING SHALL NOT EXCEED 30 PSI. EFFECTIVE CHIP
GUARDING INCLUDING EYE PROTECTION IS REQUIRED.
CAUTION: THE WATER USED TO WASH THE CELLS OR BATTERY WILL BECOME CAUSTIC; AVOID
CONTACT WITH IT. DO NOT CLEAN WITH SOLVENTS, ACIDS OR ANY CHEMICAL
SOLUTION. THESE MAY DAMAGE THE CELL CASE AND HARDWARE.
MarathonNorco Aerospace, Inc.
OPERATING and MAINTENANCE MANUAL
NICKEL-CADMIUM AIRCRAFT BATTERIES
24-34-00 Page 902
APR 15/06
If the battery has liquid electrolyte on the top of the cells, drain off as much as possible, wash with
water, and air dry. If the electrolyte has overflowed to the extent that it has run down between the
cells, the battery should be completely discharged, disassembled, and completely cleaned before
reassembling.
1. Disassembly -- Disassemble the battery as described in 11.0.
2. With the vent valves in place and locked, wash the cells under running water. Do not allow the
wash water to enter the cell's interior.
3. Dry the cells with clean absorbent toweling or with an air hose.
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：Operating and Maintenance Manual For Nickel-Cadmium Aircraft(14)