曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

the selected navigation source.
b. GPS 2 in this configuration is a GARMIN GNC 420 GPS
Navigator interfaced with the CDI (VOR/LOC Indicator). This
unit displays GPS data on the unit’s display panel and on the
remote CDI (VOR/LOC Indicator). Refer to the SR22 POH
Supplement for GARMIN GNC 420 GPS Navigator, P/N
13772-S23.
3. Dual GARMIN GNS 430 units are installed. GPS 1 in this
configuration is the uppermost GNS 430 unit in the console and
GPS 2 is the lower GNS 430 unit.
a. GPS 1 in this configuration is a GARMIN GNS 430 GPS
Navigator with VHF Com interfaced with the HSI and MFD.
Pressing the alternate-action CDI push-button on GPS 1
alternately selects GPS or NAV for display in the HSI and
MFD each time the button is depressed. The HSI source is
indicated by illumination of the “GPS” or “VLOC” annunciation
in the lower left corner of the GNS 430 display.
• Note •
The HSI displays course deviation from a VOR, Localizer
(LOC) or Glideslope (G/S) when VLOC is the navigation
source and displays GPS track deviation when GPS is
the selected navigation source.
b. GPS 2 in this configuration is a GARMIN GNS 430 GPS
Navigator with VHF Com interfaced with the CDI (VOR/LOC/
ILS/GS Indicator). Pressing the alternate-action CDI pushbutton
on GPS 2 alternately selects GPS or NAV for display in
the CDI each time the button is depressed. The HSI source is
indicated by illumination of the “GPS” or “VLOC” annunciation
in the lower left corner of the GNS 430 display.
Revised: May 25, 2005
P/N 13772-103 7 of 10
Cirrus Design Section 9
SR22 Supplements
• Note •
The CDI displays course deviation from a VOR, Localizer
(LOC) or Glideslope (G/S) when VLOC is the navigation
source and displays GPS track deviation when GPS is
the selected navigation source.
Deactivate GPS
1. Navigator Com/ Power Switch .......................... Rotate CCW ‘OFF’
Section 5 - Performance
No change from basic Handbook.
Section 6 - Weight & Balance
No change from basic Handbook.
Section 7 - Systems Description
• Note •
This supplement provides a general description of the Garmin
GNS 430, its operation, and SR22 interface. For a detailed
description of the GNS 430 and full operation instructions refer
to the Garmin GNS 430 Pilot's Guide and Reference, P/N 190-
00140-00, Revision F dated July 2000 (or later appropriate
revision).
The following paragraphs describe a single GARMIN GNS
430 unit and its functions. In the event a second GNS 430 is
installed, the second unit will function as described below
except that the GPS navigator is designated GPS 2, the NAV
receiver is designated NAV 2, and the VHF communications
receiver is designated COM 2. The GPS 2 GPS navigator and
VHF NAV is powered by 28 VDC through the Avionics Master
Switch and the 5-amp GPS2 circuit breaker on the Avionics
Non-essential Bus. 28 VDC for transceiver operation is
supplied through the Avionics master Switch and the 7.5-amp
COM2 circuit breaker on the Avionics Non-Essential Bus.
GNS 430 Integrated GPS/NAV/COM System
Revised: May 25, 2005
8 of 10 P/N 13772-103
Section 9 Cirrus Design
Supplements SR22
This airplane is equipped with a GNS 430 integrated GPS navigator,
NAV receiver, and COM transceiver. The GPS navigator consists of a
GPS receiver, a navigation computer, and a Jeppeson NavData
database all contained in the GNS 430 control unit mounted in the
center console. The GPS is designated ‘GPS 1.’ A VHF NAV receiver
and tuner for receiving VHF Omnirange (VOR), Localizer (LOC), and
Glideslope (G/S) is also integrated into the control unit. The NAV
receiver is designated ‘NAV 1.’ Additionally, a VHF communications
receiver, designated ‘COM 1,’ is also integrated into the unit. All tuning
and display controls for the GPS, NAV, and COM are located in the
GNS 430 control/display in the center console. The following
paragraphs describe the GPS, NAV, and COM functions of this unit.
For a complete description, as well as full operating instructions, refer
to the Garmin GNS 430 Pilot’s Guide and Reference.
GPS Navigator
The Garmin GNS 430 GPS navigator is the primary system (GPS 1),
is IFR certified, and is coupled to the airplane’s HSI (or HSI) and MFD.
Normally, the second GPS Navigator provides backup and is approved
for VFR use only. If the second GPS is also a Garmin 430, it will be
coupled to the CDI and is also approved for IFR use. The Garmin GPS
430 is capable of providing IFR enroute, terminal, and approach
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：AIRPLANE INFORMATION MANUAL for the CIRRUS DESIGN SR22(108)