曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

WINDOW HEAT switches.................................................................ON Position switches ON at least 10 minutes before takeoff. OVERHEAT lights – Extinguished ON lights – Illuminated (except at high ambient temperatures)
Normal Procedures -Amplified Procedures

737 Operations Manual
PITOT STATIC HEAT switches .......................................................OFF WING and ENGINE ANTI–ICE switches .......................................OFF VALVE OPEN lights – Extinguished Hydraulics ....................................................................................Normal Note: Alert ground personnel before pressurizing hydraulic
system.
System A HYDRAULIC PUMPS switches – ON
System B HYDRAULIC PUMPS switches – ON
Electric pump LOW PRESSURE lights – Extinguished
Brake pressure – 2800 PSI minimum
System A and B pressure – 2800 PSI minimum
Quantity indicators – Above RFL

Pressurization indicators ................................................................Check Cabin differential pressure – Zero Cabin altitude – Field elevation Cabin rate of climb – Zero
Exterior light switches ............................................................ As desired
Ignition select switch .............................................................IGN L or R

Alternate ignition select switch on subsequent starts. ENGINE START switches ................................................................OFF NAV switch (as installed)...................................................... As required
Select FMC, ANS-L or ANS-R position, as appropriate for navigation system to be used for departure.
Mode control panel ............................................................................. Set When selecting a value on the MCP, ensure the corresponding display on the instrument panel changes, if applicable.
COURSE(S) – Set and crosscheck
Copyright . The Boeing Company. See title page for details.
NP.20.10  June 4, 2004

Normal Procedures -Amplified Procedures

FLIGHT DIRECTOR switches – ON
Position the switch for the pilot flying to ON first.
AUTOTHROTTLE switch – OFF
Heading – Runway heading
Bank angle limit – as desired
Altitude – as desired
Autopilots – DISENGAGE

Marker Beacon Switch (as installed) .......................................As desired Clock....................................................................................................Set Left flight instruments .........................................................................Set Note: IRS alignment must be complete.
EFIS – Correct
A/T, Pitch and ROLL FMA’s - Blank
A/P STATUS FMA - FD
Flight instrument indications are correct.
Verify no flags displayed.
Altimeter - Set

MAP – Correct
Verify no flags displayed.
Route - Displayed, correct.

Standby instruments ...................................................................... Check Standby horizon – Set Erect horizon and verify proper attitude. Standby altimeter/airspeed indicator – Set Set altimeter and verify airspeed is zero.
Normal Procedures -Amplified Procedures 737 Operations Manual

NOSE WHEEL STEERING switch (as installed) ................................................................................. NORM
Light controls .......................................................................... As desired

Fuel quantity indicators..................................................................Check Test IAW the supplementary procedure.
Fuel flow switch (Non-EIS) ............................................................ Reset N1 manual set knobs ........................................................................Press Permits FMC control of the N1 cursors. Engine Instruments ........................................................................Check Primary and secondary engine indications - Normal
.
engine indications display existing conditions

.
 no exceedance values are displayed

.
 engine oil quantity meets dispatch requirements

ENG OIL QTY TEST switch (Non-EIS airplanes) ......................................................................... Push
Verify both indicators move toward zero and return to the original setting when the switch is released.
Fuel used reset switch (EIS)............................................................Reset

ANTISKID switch ............................................................................. ON Verify ANTISKID INOP light extinguished.
AUTO BRAKE select switch........................................................... RTO AUTOBRAKE DISARM light – extinguished
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300機組操作手冊Flight Crew Operations Manual FCOM 1(35)