R 1EFF : 001-049, 051-099, 101-105, 151-156, 1 31-51-77Page 58 1201-203, 1May 01/05 1 1 1CES 1

 Compressor vane
 Figure 046

R 1EFF : 001-049, 051-099, 101-105, 151-156, 1 31-51-77Page 59 1201-203, 1May 01/05 1 1 1CES 1

 Type disagree
 Figure 047

R 1EFF : 001-049, 051-099, 101-105, 151-156, 1 31-51-77Page 60 1201-203, 1May 01/05 1 1 1CES 1

 ENG T.O Thrust Disagree
 Figure 048

R 1EFF : 001-049, 062-099, 101-105, 151-156, 1 31-51-77Page 61 1201-203, 1May 01/05 1 1 1CES 1

 ENG THR Levers not Set
 Figure 049

R 1EFF : 001-049, 062-099, 101-105, 151-156, 1 31-51-77Page 62 1201-203, 1May 01/05 1 1 1CES 1 FWC - ACQUISITION/INTERFACE - DESCRIPTION AND OPERATION

_______________________________________________________
 1. General
_______ The interfaces between the various aircraft systems and the FWC are defined by giving the main features of each signal in table form, except for the discrete and the boolean on bus input signals. Several signal types are used, i.e.:
 -wired discretes,
 -boolean on bus,
 -digital on bus,
 -analog on synchro,
 -supplies and miscellaneous.
 2. Signal Types
____________
 A. Wired Discretes
 Each wired discrete is assigned to a computer input pin.

 (1)
 P-This type of discrete is defined by the two states (on data bus):

 -
logic 0 : the computer detects ground

 -
logic 1 : the computer detects absence of ground.

 (2)
 P+
 This discrete is defined by the two states:

 -
logic 1 : the computer detects +28VDC

 -
logic 0 : the computer detects absence of 28VDC.

 (3)
 P- off

 -
logic 0 : the computer detects disappearance of ground

 -
logic 1 : the computer detects a permanent ground.

 (4)
 P+ off

 -
logic 1 : the computer detects disappearance of +28VDC

 -
logic 0 : the computer detects permanent +28VDC.

 NOTE : Some discretes are inversed (P- at logic 1 : ground) for their
____
 use in the logics.

 There are also output discretes. Controlled by the computer, logic 1 is represented by a ground and logic 0 by open circuit. They permit illumination of an annunciator light or closing of a relay.
R 1EFF : 001-049, 051-099, 101-105, 151-156, 1 31-52-00Page 1 1201-203, 1Config-1 May 01/05 1 1 1CES 1

 B. Boolean on Bus These data have two states. The computer copies the state of the corresponding bit on one of the ARINC buses addressed to the computer on its input port. Inversely, at output, the computer puts label bits assigned to booleans to be transmitted on its data bus. For example, the computer sets the label 126 SDI 10 bit 9 to 1 on its data bus when it computes AP OFF WARNING.
 C. Digital on Bus The received data requires a large number of bits available on an input bus label. E.g., on label 370 (SDI : 01) from DMC/L, 16 bits are used for DECISION HEIGHT which gives a range of 8192 feet for a resolution of 0.125 feet. In the same way on label 173 (SDI : 01) from ILS 1 receiver, 12 bits are used for LOC DEVIATION which gives a range of 0.4DDM for a resolution of 0.0001 DDM.
 D. Analog on Synchro The data received on three of the input pins is of the same type as that which normally supplies an indicator with a pointer (the combination of amplitudes of the three voltages at 400 Hz privileges a direction in a plane). Therefore the data is essentially angular.
 E. Power Supplies The FWC 1 is supplied by the 115VAC ESS BUS 401 XP-C via circuit breaker 3WW. The FWC 2 is supplied by the 115VAC BUS 2 204 XP-A via circuit breaker 2WW.
 F. Miscellaneous Certain pins are assigned to signals other than those mentioned above. For example, signals which synchronize audio outputs or test pins intended for software development.
R 1EFF : 001-049, 051-099, 101-105, 151-156, 1 31-52-00Page 2 1201-203, 1Config-1 May 01/05 1 1 1CES 1

 3. Re-labelling
____________
 Certain digital or boolean data are retransmitted on the computer output bus
 under another label.
 The list follows:
 -------------------------------------------------------------------------------| LABEL-Output SDI | LABEL-Input SDI | /Computer | |-------------------------|-------------------------|-------------------------| | 004-01 | 173-01 | /ILS1 | | 004-10 | 173-10 | /ILS2 |
R **ON A/C 001-049, 062-099, 101-105, 151-156, 201-203,
R Post SB 31-1141 For A/C 001-049,062-099,101-105,151-156,201-203,
 | 004-01 | 173-01 | /ILS1 | | 004-11 | 270-01 | /SATCOMHS | | 004-10 | 173-10 | /ILS2 |
　
中國航空網(wǎng) www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM 指示/記錄系統(tǒng) 6(28)