(1) Do the BITE test of the CIDS through the programming and test panel (PTP) (Ref. AMM TASK 23-73-00-740-003), or through the centralized fault display system (CFDS) (Ref. AMM TASK 23-73-00-740-005).
4. Fault Isolation
_______________
A. If the test gives a different maintenance message:
- Do the trouble shooting procedure related to the maintenance message.
B. If the test gives the maintenance message SLIDE BOTTLE EXIT R, or DEU-B 300RH4:
- get access to the inflation reservoir (Ref. AMM TASK 25-62-49-000-001),
NOTE : Only use the access procedure.
____
- make sure the gage needle of the inflation reservoir pressure-gage is positioned over the green cursor, or to the right of the green cursor.
一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一 R EFF : 301-399, ∞∞25-62-00∞∞∞∞∞∞∞∞∞∞Page 220
Aug 01/05 CES
NOTE : The green cursor of the pressure gage is temperature compensated,
____ and reacts to temperature changes faster than the gas expansion in the inflation reservoir. The green cursor moves independently of the pointer when a temperature change occurs.
(1) If the pressure indication is not correct:
- replace the PRESSURE BOTTLE DOOR 3RH (7777MM), (Ref. AMM TASK 25-62-49-000-001) and (Ref. AMM TASK 25-62-49-400-001).
(2) If the pressure indication is correct:
- replace the DEU-B (300RH4), (Ref. AMM TASK 23-73-47-000-001) and (Ref. AMM TASK 23-73-47-400-001).
(3) If the fault continues:
- do a check and repair the wiring between the: DEU-B (300RH4) connector C/37 and the SLIDE BOTTLE PRESS SENSOR connector A/A (Ref. ASM 25-65/01) and (Ref. ASM 23-73/11).
- close access to the inflation reservoir (Ref. AMM TASK 25-62-49-400-001).
NOTE : Only use the close-up procedure.
____
C. Do the test as given in paragraph 3. A. to check the correct operation (no maintenance message is shown).
TASK 25-62-00-810-811
Escape Slide/Escape Slide (Raft) Light for the LH FWD Passenger/Crew Door Inoperative
1. Possible Causes
_______________
- ESCAPE SLIDE FWD L (7500MM)
- POWER-EMERGENCY SUPPLY (10WL)
- aircraft wiring
2. Job Set-up Information
______________________
A. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
AMM 25-62-44-000-002 Removal of the Escape-Slide Pack-Assembly AMM 25-62-44-000-009 AMM 25-62-44-400-001 Installation of the Escape-Slide Pack-Assembly AMM 25-62-44-400-005 AMM 33-51-00-710-001 Operational Test of Emergency Lights by 'TEST EMER
LIGHT SYS' Pushbutton AMM 33-51-38-000-001 Removal of the Emergency Power-Supply Unit (EPSU) AMM 33-51-38-400-001 Installation of the Emergency Power-Supply Unit
(EPSU) ASM 33-51/01
3. Fault Confirmation
__________________
A. Do the operational test of the emergency lighting system (Ref. AMM TASK 33-51-00-710-001).
4. Fault Isolation
_______________
A. If the test gives the maintenance message EPSU EXT LOAD FWD L (10WL) :
- replace the SLIDE/RAFT, DOOR 1, LH ESCAPE SLIDE FWD L (7500MM) (Ref. AMM TASK 25-62-44-000-002) and (Ref. AMM TASK 25-62-44-400-001) or (Ref. AMM TASK 25-62-44-000-009) and (Ref. AMM TASK 25-62-44-400-005).
(1) Do the test given in para. 3.
(a) If the fault continues:
- replace the POWER-EMERGENCY SUPPLY (10WL) (Ref. AMM TASK 33-51-38-000-001) and (Ref. AMM TASK 33-51-38-400-001).
一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一 EFF : ALL ∞∞25-62-00∞∞∞∞∞∞∞∞∞∞Page 222
Nov 01/04R
CES (b) If the fault continues:
- do a check and repair the aircraft wiring from the POWER-EMERGENCY SUPPLY (10WL) to the escape slide/escape slide (raft) connector 2871VC (Ref. ASM 33-51/01).
(2) Do the test given in para. 3.
一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一 EFF : ALL ∞∞25-62-00∞∞∞∞∞∞∞∞∞∞Page 223
Nov 01/04R
CES
Escape Slide/Escape Slide (Raft) Light for the RH FWD Passenger/Crew Door
Inoperative
1. Possible Causes
_______________
- ESCAPE SLIDE FWD R (7501MM) 中國航空網 www.k6050.com 航空翻譯 www.aviation.cn 本文鏈接地址：A320 Trouble Shooting Manual EQUIPMENT/FURNISHINGS(28)
