(b) Do the EIS start procedure (Upper ECAM DU and lower ECAM DU only)
(c) On the panel 21VU, push the OXYGEN/CREW SUPPLY pushbutton switch (the OFF legend goes off).
「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1 EFF : ALL ∞∞35-10-00∞∞∞∞∞∞∞∞∞∞Page 226
Nov 01/02R
CES B. Make sure that this(these) circuit breaker(s) is(are) closed:
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------49VU OXYGEN/CREW/OXY/SPLY 1HT HA01
C. Test
(1) On the ECAM control panel:
- push the DOOR key to get the DOOR/OXY page.
(2) Make sure that the OXY pressure indication is minimum on the DOOR/OXY page.
(3) Do an OXY high-pressure indication direct reading (Ref. AMM TASK 35-10-00-040-001).
(4) Make sure that the overboard discharge indicator is yellow.
4. Fault Isolation
_______________
A. If the oxygen pressure indication is the same on the SD and on the pressure gage with the overboard discharge indicator yellow:
- replace the CYLINDER-OXYGEN STORAGE (5750HM) (Ref. AMM TASK 35-11-41-000-001) and (Ref. AMM TASK 35-11-41-400-001) and replace the overboard discharge indicator (5756HM) (Ref. AMM TASK 35-13-22-920-001).
(1) If the oxygen pressure indication is different on the SD and on the pressure gage with the overboard discharge indicator yellow:
- replace the XMTR/PRESS REG-OXY (4HT) (Ref. AMM TASK 35-13-15-000-001) and (Ref. AMM TASK 35-13-15-400-001) and replace the overboard discharge indicator (5756HM) (Ref. AMM TASK 35-13-22-920-001).
B. Test
(1) Make sure that the OXY pressure indication is normal (more than 1500PSI) on the DOOR/OXY page.
5. Close-up
________
A. Put the aircraft back to its initial configuration.
(1) On the panel 21VU, release the OXYGEN/CREW SUPPLY pushbutton switch (the OFF legend comes on).
(2) On the ECAM control panel, set the UPPER DISPLAY and LOWER DISPLAY potentiometers to OFF. (Ref. AMM TASK 31-60-00-860-002)
(3) De-energize the aircraft electrical circuits
(Ref. AMM TASK 24-41-00-862-002).
「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1 EFF : ALL ∞∞35-10-00∞∞∞∞∞∞∞∞∞∞Page 227
Nov 01/02R CES
TASK 35-10-00-810-815
Failure of the Oxygen Flow Indicator
1. Possible Causes
_______________
- STOWAGE BOX-OXY MASK, CAPT (10RN1)
- STOWAGE BOX-OXY MASK, F/O (10RN2)
- STOWAGE BOX-OXY MASK, 3RD OCCPNT (10RN3)
- BOX ASSY-STOWAGE, 4TH OCCPNT (5774HM)
2. Job Set-up Information
______________________
A. Referenced Information
-------------------------------------------------------------------------------
REFERENCE DESIGNATION
-------------------------------------------------------------------------------
AMM 35-12-41-000-001 Removal of the Oxygen-Mask Stowage-Box
AMM 35-12-41-400-001 Installation of the Oxygen-Mask Stowage-Box
AMM 35-12-41-710-001 Operational Test of the Full Face/Quick Donning
R Oxygen Masks (5757HM,5758HM,5759HM,5760HM)
3. Fault Confirmation
__________________
A. Test
(1) Do the operational test of the full-face/quick-donning oxygen masks (Ref. AMM TASK 35-12-41-710-001).
4. Fault Isolation
_______________
A. If during the operational test:
(1) The Captain oxygen flow-indicator is inoperative
- replace the STOWAGE BOX-OXY MASK, CAPT (10RN1) (Ref. AMM TASK 35-12-41-000-001) and (Ref. AMM TASK 35-12-41-400-001). 中國航空網(wǎng) www.k6050.com 航空翻譯 www.aviation.cn 本文鏈接地址：A320 Trouble Shooting Manual 排故手冊(cè) 氧氣 OXYGEN(17)
