NOTE: It will be necessary to press together front end of tail cone slightly to facilitate removal.
D. If new tail cone is to be installed, remove elevator index plates and rudder index plate (Ref Chapter 27, Elevator Index Plate - R/I and Rudder Index Plate - R/I).
543
Jun 20/89 BOEING PROPRIETARY - Copyright . - Unpublished Work - See title page for details. 53-53-0 Page 401
4. Install Tail Cone
A. Check that ACC COMP LITS circuit breaker on P18 is open. On airplanes with a tail cone oscillating navigational light, check that OSC NAV LT circuit breaker on P18 is open.
B. Place tail cone on bulkhead making sure that alignment marks align and install washers and fasteners.
C. Remove protective plastic shields.
D. If new tail cone is being installed, install elevator index plates and rudder index plate (Ref Chapter 27, Elevator Index Plate - R/I and Rudder Index Plate - R/I).
E. Connect wire bundle at electrical connector located on bulkhead at body station 1156.
5. Restore Airplane to Normal Configuration
A. If removed, connect elevator control pushrods or install elevator (Ref 27-31-11 R/I).
B. Install exhaust duct and aft fairing (Ref Chapter 49, Exhaust Duct - R/I and Aft Fairing - R/I).
C. Install access panels.
D. Close circuit breakers.
543
53-53-0 Page 402 BOEING PROPRIETARY - Copyright . - Unpublished Work - See title page for details. Jun 20/89
中國航空網 www.k6050.com 航空翻譯 www.aviation.cn 本文鏈接地址:737 AMM 飛機維護手冊 機身 FUSELAGE(24)