曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

Location
There are PSUs under the outboard and center stowage bins, above the passenger seats. There are also PSUs at attendant stations (not shown) and in lavatories (not shown).
Training Information Point
You use an allen wrench or a cylindrical rod to open a PSU. You put the tool through the access notch (outboard PSUs) or hole (center PSUs) and push on the latch. You can open the PSU from either side. To remove a PSU you open it from one side and then release the other latches from inside the PSU.
The outboard PSUs are interchangeable.
When you replace a PSU, make sure you install it so that the correct end points forward.
EFFECTIVITY BEJ ALL  25-20-00 
Page 18 
D633W101-BEJ  Sep 05/2002 

 

PASSENGER COMPARTMENT -PASSENGER SERVICE UNITS

EFFECTIVITY BEJ ALL  25-20-00 
Page 19 
D633W101-BEJ  Jan 05/2002 

PASSENGER COMPARTMENT -FULL-HEIGHT CLOSETS -INTRODUCTION

Physical Description
Full-height closets extend from the floor to the ceiling. Outboard closets have a curved side to fit against the side of the passenger compartment. Center closets have straight sides and go in the center of the passenger compartment. The closets have this equipment (not shown):
*
Coat rods

*
Lights

*
Panel doors

*
Magazine stowage compartments.

Location
You can install or move the closets anywhere within the flexibility zones.
EFFECTIVITY BEJ ALL  25-20-00 
Page 20 
D633W101-BEJ  Sep 05/2002 

 

PASSENGER COMPARTMENT -FULL-HEIGHT CLOSETS -INTRODUCTION

EFFECTIVITY BEJ ALL  25-20-00 
Page 21 
D633W101-BEJ  Jan 05/2002 

PASSENGER COMPARTMENT -FULL-HEIGHT CLOSETS -TRAINING INFORMATION POINTS

Training Information Point
The top of the closet attaches to the airplane structure by a tie rod. You can adjust the length of the tie rod to make it fit correctly. The closet light wiring has a connector above the closet.
The bottom of the closet attaches at four corners to the seat tracks by bolts and fittings. Install up to three washers at a corner to level the closet. You can rotate the eccentric fitting 180 degrees to make it fit correctly.
The seat track fittings align to the seat track lip. Tolerance build-ups in the seat tracks can cause the seat track holes at the splice to not align correctly. The special fittings align to the seat track lip to permit installation of the fittings at the splice.
EFFECTIVITY BEJ ALL  25-20-00 
Page 22 
D633W101-BEJ  Sep 05/2002 

 

PASSENGER COMPARTMENT -FULL-HEIGHT CLOSETS -TRAINING INFORMATION POINTS

EFFECTIVITY BEJ ALL  25-20-00 
Page 23 
D633W101-BEJ  Jan 05/2002 

PASSENGER COMPARTMENT -PARTITIONS

Purpose
Partitions make a different area in the passenger compartment for the flight attendants. Folding attendant seats or tables attach to some partitions.
Location
You can install or move the partitions anywhere within the flexibility zones.
Physical Description
Partitions extend from floor to ceiling. Outboard partitions have a curved side to fit against the side of the passenger compartment. Center partitions have straight sides and go in the center of the passenger compartment. Partitions may include such items as:
*
Folding tables

*
Stowage compartments

*
Wall-mounted attendant seats.

EFFECTIVITY BEJ ALL  25-20-00 
Page 24 
D633W101-BEJ  Sep 05/2002 

 

777 AIRCRAFT MAINTENANCE MANUAL

PASSENGER COMPARTMENT -PARTITIONS

EFFECTIVITY BEJ ALL  25-20-00 
Page 25 
D633W101-BEJ  Jan 05/2002 

PASSENGER COMPARTMENT -PARTITIONS -TRAINING INFORMATION POINTS

Training Information Point
The top of the partitions attach to the airplane structure with tie rods. Adjust the length of the tie rod so it fits correctly. The electrical wiring has a connector above the partition.
The bottom of the partitions attach to the seat tracks with bolts and fittings.
EFFECTIVITY BEJ ALL  25-20-00 
Page 26 
D633W101-BEJ  Sep 05/2002 

 

PASSENGER COMPARTMENT -PARTITIONS -TRAINING INFORMATION POINTS

EFFECTIVITY BEJ ALL  25-20-00 
Page 27 
D633W101-BEJ  Jan 05/2002 

PASSENGER COMPARTMENT -CLASS DIVIDERS

Purpose
Class dividers isolate the passenger compartment seating areas. Literature pockets attach to some class dividers.
Location
You can install or move the class dividers anywhere within the flexibility zones.
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：777 AMM 飛機維護手冊 Equipment and Furnishings(7)