AMC M.A.606 (h)(2) Personnel requirements
1.  For the issue of a limited certification authorisation the commander should hold either a valid air transport pilot license (ATPL), or commercial pilots license (CPL), or a national equivalent acceptable to the competent authority on the aircraft type. In addition, the limited certification authorisation is subject to the maintenance organi-sation manual containing procedures to address the following:
a.  
Completion of adequate maintenance airworthiness regulation training.

b.  
Completion of adequate task training for the specific task on the aircraft. The task training should be of sufficient duration to ensure that the individual has a thorough understanding of the task to be completed and should involve training in the use of associated maintenance data.

c.  
Completion of the procedural training.

ED 2008/013/R  ED 2006/11/R
Section A
PART-M
Subpart F

ED 2008/013/R
The above procedures should be specified in the maintenance organisation manual and be accepted by the competent authority.
2.  Typical tasks that may be certified and/or carried out by the commander holding an ATPL or CPL are minor maintenance or simple checks included in the following list:
a.  
Replacement of internal lights, filaments and flash tubes.

b.  
Closing of cowlings and refitment of quick access inspection panels.

c.  
Role changes, e.g., stretcher fit, dual controls, FLIR, doors, photographic equip-ment etc.

d.  
Any check/replacement involving simple techniques consistent with this AMC and as agreed by the competent authority.

3.  The authorisation should have a finite life of twelve months subject to satisfactory recurrent training on the applicable aircraft type.

ED 2008/013/R
AMC M.A.607 Certifying staff

1.  
Adequate understanding of the relevant aircraft and/or aircraft component(s) to be maintained together with the associated organisation procedures means that the person has received training and has relevant maintenance experience on the prod-uct type and associated organisation procedures such that the person understands how the product functions, what are the more common defects with associated con-sequences.

2.  
All prospective certifying staff are required to be assessed for competence, qualifica-tion and capability related to intended certifying duties. Competence and capability can be assessed by having the person work under the supervision of another certify-ing person for sufficient time to arrive at a conclusion. Sufficient time could be as little as a few weeks if the person is fully exposed to relevant work. The person need not be assessed against the complete spectrum of intended duties. When the person has been recruited from another approved maintenance organisation and was a cer-tifying person in that organisation then it is reasonable to accept a written confirma-tion from the previous organisation.

3.  
The organisation should hold copies of all documents that attest to qualification, and to recent experience.

AMC M.A.607 (c) Certifying staff
1.  The following minimum information as applicable should be kept on record in respect of each certifying person:
(a)
name;

(b)
date of birth;

(c)  
basic training;

(d)
type training;

(e)  
recurrent training;

(f)  
specialised training;

(g)
experience;

(h)
qualifications relevant to the approval;

(i)  
scope of the authorisation and personal authorisation reference;

(j)  
date of first issue of the authorisation;

(k)
if appropriate – expiry date of the authorisation.
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：CONTINUING AIRWORTHINESS REQUIREMENTS – PART M 1(43)