曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

Engine Start/Ignition Selector
The engine start/ignition selector supplies a ground for the start power relay when it is in the START position. This gives the EEC power during engine starts.
EEC Maintenance Switch
The EEC maintenance switch supplies a ground for the start power relay when it is in the TEST position. This gives the EEC power during tests and maintenance operations.
The AIMS sends the EEC maintenance switch position to the EEC.
EFFECTIVITY BEJ ALL  73-21-00 
Page 32 
D633W101-BEJ  Sep 05/2002 

 

ENGINE FUEL CONTROL -EEC POWER -FUNCTIONAL DESCRIPTION

EFFECTIVITY BEJ ALL  73-21-00 
Page 33 
D633W101-BEJ  Sep 05/2002 

ENGINE FUEL CONTROL -EEC WIRING HARNESS BIFURCATION CONDUIT

General
To move the engine from one location to another, you may need to separate the engine fan from the core. The EEC wiring harness bifurcation conduit makes this separation easier.
The conduit is the connection between wiring harnesses that go from the fan case to the core case. It permits you to disconnect the fan case wiring harnesses at the fan and the core harnesses at the core. You can then remove the conduit as a unit.
The conduit attaches to the fan case and high pressure compressor (HPC) case. The fan case electrical connections are on the left side of the conduit. The core electrical connections are on both sides of the conduit.
EFFECTIVITY BEJ ALL  73-21-00 
Page 34 
D633W101-BEJ  Sep 05/2002 

 

ENGINE FUEL CONTROL -EEC WIRING HARNESS BIFURCATION CONDUIT

EFFECTIVITY BEJ ALL  73-21-00 
Page 35 
D633W101-BEJ  Sep 05/2002 

ENGINE FUEL CONTROL -EEC TEMPERATURE SENSORS

T3 Thermocouple Probe
The T3 thermocouple probe supplies a signal of HPC outlet air temperature to the EEC. The EEC uses it to control engine start fuel schedules. The probe attaches to the diffuser case on the left side of the engine at approximately the 10:00 position.
Fuel Temperature Sensor
The fuel temperature sensor supplies a signal to the EEC. The EEC uses it to control the fuel/oil cooler bypass valve and the engine air/oil cooler valve. The sensor measures the fuel temperature as fuel leaves the fuel/oil cooler. The probe attaches to the fuel outlet line on the rear of the fuel/oil cooler.
The EEC also sends the fuel temperature data to the AIMS through the EDIU. The AIMS shows the engine fuel temperature on the electronic propulsion control system (EPCS) maintenance page 2.
EFFECTIVITY BEJ ALL  73-21-00 
Page 36 
D633W101-BEJ  Sep 05/2002 

 

ENGINE FUEL CONTROL -EEC TEMPERATURE SENSORS

EFFECTIVITY BEJ ALL  73-21-00 
Page 37 
D633W101-BEJ  Sep 05/2002 

　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：777 AMM 飛機維護手冊 發動機和燃油控制 Engine Fuel and Control PW 777 AIRCRAFT MAINTENANCE MANUAL(18)