S 094-025
 WARNING: USE THE PROCEDURE IN AMM 32-00-15/201 TO REMOVE THE DOOR LOCKS.
_______ THE DOORS OPEN AND CLOSE QUICKLY AND CAN CAUSE INJURY TO PERSONS OR DAMAGE TO EQUIPMENT.
 (15) Remove the door locks from the landing gear doors and close the doors (AMM 32-00-15/201).
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 28-11-08
 ALL  ú ú 01 Page 405 ú May 28/99

A

757 MAINTENANCE MANUAL
 FUEL TANK ACCESS DOORS - APPROVED REPAIRS
_________________________________________
 1.  General_______
 A.  This procedure has one task. The task is the replacement of the molded rubber door seal for the access panels. You can use this procedure to replace all the rubber seals on high impact resistant access panels. All new replacement Cast Aluminum access panels will also have molded rubber seals you can remove and replace.
 TASK 28-11-10-908-000
 2.  Replacement of the Molded Rubber Door Seal__________________________________________
 A.  Equipment
 (1)
Wipers - Absorbent, BMS 15-5 Class A

 (2)
Water - Clean, tap

 (3)
Air gun

 (4)
Sealant gun

 (5)
Sealant removal tool - wood or plastic

 B.  
Consumable Materials

 (1)
A00413 Sealant - Adhesive, BMS 5-26

 (2)
A00908 Sealant - Adhesive, Proseal 860 B1/6

 (3)
B00349 Solvent - Methyl Ethyl Ketone TT-M-261

 (4)
B00316 Naphtha - Aliphatic TT-N-95

 (5)
G02167 Sandpaper - Scotchbrite

 C.  
References

 (1)
AMM 28-11-00/801, Integral Fuel Tanks

 D.  
Access

 (1)  
Location Zones 134 Wing Center Section (Right) 194 Wing to Body - Forward Lower Half (Right) 531 Center Wing Tank (Left) 631 Center Wing Tank (Right) 541 Main Tank - rib No. 5 to rib No. 17 (Left) 542 Main Tank - rib No. 17 to rib No. 21 (Left) 641 Main Tank - rib No. 5 to rib No. 17 (Right) 642 Main Tank - rib No. 17 to rib No. 21 (Right)

 E.  
Procedure

 (1)
Remove the seal from the door fully.

 S 028-002
 NOTE: If the seal cannot be removed from a Cast Aluminum access
____ panel the access panel does not have a molded rubber seal that you can remove and replace. You must replace the full access panel. Only new Cast Aluminum access panels have molded rubber seals you can remove and replace.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：757 AMM 飛機維護手冊 燃油 CHAPTER 28 - FUEL 2(17)