曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

3) USE OF THE FCU PUSHBUTTON
Use of the FCU pushbutton is considered to be an involuntary A/THR off command (e.g. in the case of a failure). When pressed, thrust is frozen and remains locked at the value it had when the flight crew pressed the A/THR pushbutton, as long as the thrust levers remain in the CLB or MCT detent.
If thrust levers are out of detent, thrust is manually controlled and, therefore, unlocked.
An ECAM caution and an FMA message trigger during thrust lock:
‐ THR LK appears in amber on the FMA
‐ The ECAM caution is:
AUTO FLT: A/THR OFF THR LEVERS MOVE ENG: THRUST LOCKED THR LEVERS MOVE
In this case, when the flight crew moves the thrust levers out of detent, full manual control is recovered, and the THRUST LOCKED message disappears from the FMA.
This feature should not be used, unless the instinctive disconnect pushbuttons are inoperative.
ALPHA FLOOR
When the aircraft's angle-of-attack goes beyond the ALPHA FLOOR threshold, this means that the aircraft has decelerated significantly (below ALPHA PROT speed): A/THR activates automatically and orders TOGA thrust, regardless of the thrust lever position.
The example below illustrates that:
? The aircraft is in descent with the thrust levers manually set to IDLE.
? The aircraft decelerates, during manual flight with the FD off, as indicated on the FMA.
Speed Scale and FMA Indications in a Typical A Floor Case
 
 
OPERATIONAL PHILOSOPHY
AP / FD / ATHR
 
When the speed decreases, so that the angle-of-attack reaches the ALPHA FLOOR threshold, A/THR activates and orders TOGA thrust, despite the fact that the thrust levers are at IDLE.
When the aircraft accelerates again, the angle-of-attack drops below the ALPHA FLOOR threshold.
TOGA thrust is maintained or locked. This enables the flight crew to reduce thrust, as necessary. TOGA LK appears on the FMA to indicate that TOGA thrust is locked. The desired thrust can only be recovered by setting A/THR to off, with the instinctive disconnect pushbutton.
ALPHA floor is available, when the flight controls are in NORMAL LAW, from lift off to 100 ft RA at landing. It is inhibited in some cases of engine failure.
A/THR USE - SUMMARY
Use of A/THR is recommended during the entire flight. It may be used in most failures cases, including:
? Engine failure, even during autoland
? Abnormal configurations
However, use of manual thrust is recommended when the autotrim function is lost. The aim of this recommendation is to avoid large thrust changes.
A/THR use in flight
 
A/THR should be monitored via the:
? FMA – SPEED / SPEED TREND on the PFD
? N1/N1 command (EPR) on the ECAM E/WD.
 
OPERATIONAL PHILOSOPHY
AP / FD / ATHR
 
AP, FD, A/THR MODE CHANGES AND REVERSIONS
Applicable to: ALL
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A330/A340 機組訓練手冊 FCTM Flight Crew Training Manual 1(17)