. The ELT can now be activated. 

 
Figure 3 - Portable Configuration
2. Installation

2.1 Introduction to Installation

Installations must be made by qualified personnel in accordance with FAA regulations. Duplicating a previous installation may not be acceptable. Refer to the following:
. FAA – Advisory Circular 43.13 (Acceptable Methods, Techniques, and Practices – Aircraft Alterations), specifically, Chapters 1 through 3, 11 and 13. Found at www.faa.gov, or specifically: http://www.airweb.faa.gov/Regulatory_and_Guidance_Library/rgAdvisoryCircular.nsf/0/E533BB05389C90E486256A54006E47B2?OpenDocument 

. TSO C126 Paragraph D Requirements:

“The conditions and tests required for TSO approval of this article are minimum performance standards. It is the responsbility of those desiring to install this article on a specific type or class of aircraft to determine that the aircraft installation conditions are within the TSO standards. The article may be installed only if further evaluation by the applicant documents an acceptable installation and i is approved by the administrator.”
 Found at www.faa.gov/certification/aircraft/,  
. RTCA DO-182 recommends:

“All ELT system components which must survive a crash intact,…should be attached to the airframe in such a manner that the attachment system can support a 100g load…in the plus and minus directions of the three principal axes of the aircraft.”
 RTCA documents may be obtained from:
 
RTCA, Inc.
1828 L Street, NW
Suite 805
Washington, DC 20036
Tel: 202-833-9339
Fax: 202-833-9434
www.rtca.org 
info@rtca.org 
NOTE:  Installation in a pressurized aircraft constitutes a major modification. Consult the Department of Transportation Regional Officer before proceeding.
NOTE: Aircraft manufacturers may also have guidance on ELT installation. Refer to and follow any applicable Type Approval or STC data for your aircraft.  If located outside of the US, follow all applicable regulations for your national authority.
2.2 Parts List

Installation kits offered for the ME406Pinclude the necessary ELT-related components. The table below lists typical options. Parts can be ordered separately. Additional parts may also be available. Contact Artex at 1-800-547-8901 for details, pricing and availability. 
Item
 Option / Notes
 Artex P/N
 
ELT w/ battery pack
 ME406P
 453-6611
 
Battery Pack
 Kit, see Battery Replacement section of this manual
 455-0012
 
Mounting tray
 One option available
 452-3075
 
Antenna
 Portable
 110-775 (Figure 22)
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：DESCRIPTION, OPERATION, INSTALLATION AND MAINTENANCE MANUAL ME406P ELT(11)