曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

angle and the maximum rate of climb at sealevel as well as the velocities and lift
coefficients at which they occur.
160             PERFORMANCE, STABILI-fY, DYNAMICS, AND CONTROL
2.8    A propeller airElane has a wing loading of 1750 N/m2, wing area of 30 m2,
CD - 0.02 +0.04C~:'and C~,    x =  1.5. The propulsive efficiency is 0.85. What
should be the power developed by the reciprocating engine to achieve a maximum
rate of climb of 12 m/s at sea levjei?
2.9    The drag polar of a turbojet airplane is given by
   - ,-l-.C2
CD = CDO + n-Ae
Assunung that the thrust is independent of fiight speed,.show that the dynamic
pressure when the rate of climb is maximum is given by
     T
q = 6S~-+
2.10    An aircraft is powered by a turbojet engine and has a maximum speed of
790 krn/h at sea level. The gross weight of the vehicle is 160,000 N, wing area is
50 II12, and CD  " 0.02 + 0.04C~. Find (a) the thrust developed by the engine,
(b) climb angle and rate of climb when :Oying at 75r/;o maximum aerodynamic
 efficiency, and (c) maximum rate of climb and velocit)r at which it occurs. [Answer:
(a) 30,118.94 N, (b) 6.5171 deg and 14.5229 m/s, and (c) 14.547 m/s at 129.06 m/s.]
2.11      At a sealevel speed of200 m/s, the pilot of a certainjet aircraft can achieve a
rate of climb of20 m/s.lnstead of climbing, the pilot chooses to accelerate, holding
the altitude constant  Determine the maximum speed achieved at sealevel. Assume
 W = 200,000 N, S = 60 m2, and CD  - 0.021+0.042CZ. [Answer: 257.8538 m/s.]
2.12     Ajet air~~~4e2wn~lghs 160,000 N and has a zero-hft drag coefficient of0.008
 and a wing area c            m2. At  100 m/s at sea level, the rate ofclimb is  11.5 m/s. The
thrust developed by the engines is equal to 27,000 N. Determine the maximum
rate of climb and the corresponding fiight speed at sea level. [Answer: 22.75 m/s
and 211.06 m/s.]
2.13    Ajet aircraft weighs 150,000 N and has a wing area of30 m2.1ts drag polar
is given by CD  = 0.015 + 0.025C2. The sea level thrust To is equal to 23,200 N,
and the thrust at altitude is given by T  =  Too . The specific fuel consumption at sea
level co is 1.2 NtNfh and, at altitude, c - coa. Determine (a) the most economical
cruise altitude and (b) fuelload and cnuse velocity for a Breguet range of2500 k:m.
[Answer: (a) 12.31 km and (b) 6030.0 N and 205.166 m/sJ
2.14   If the aircraft in Exercise 2.13 encountered a steady tailwind of 35 km/h
during the cruise, how much fuelis saved'? fAnswer: 492.19 N.]
2.15    If the aircraft in Exercise 2.13 followed a constant-altitude range program,
find (a) cruise altitude and (b) fuel required to cover a still-air range of 2500 km.
[Answer: (a) 11.2059 km and (b) 6361 N.]
AIRCRAFT PERFORMANCE
161
2.17  A jet aircraft has the following data: W  -. 50,000 N, CD - 0.025+
0.03CZ, CL = 0.08ct, S = 30 m2, T = 15,OOOcr0.6 N, and c = l.0o.0.2 N/Nh.
       If the airplane cruises at an angle ofattack of5 deg, determine the percent change
in the fijel consumption compared to the minimum possible fuel consumption to
cover a range of 1500 km at an altitude of 11 km (cr  -- 0.293). Assume that the
pilot constantly monitors the speed to prevent the aircraft from gaining altitude.
[Answer: 3.4681J
2.19     (a) For a coordinated constant- velocitjr tumin a horizontalplane,derive the
expressions for the turn rate and radius of turn for flight at limit load factor forjet
aircraft.
     (b) Show that for MSTR and SST, the lift-to-drag ratios are respectively given
by
                    2n Em
(1) E-( +~2~
                   2zn Em
(2) E=( +L:?22~
2.20   A propeller airplane weighs 45,000 N and has a wing area of 28 m2. The
drag polar is given by CD  = 0.021 + 0.045C2, and the maximum lift coe:fficient
is 1.5. The power devyeio;ed by the engine is 900 kW with a propulsive efficiency
of 0.82. The structural         t load factor is 3.0.
     Determine the performance characteristics for (a) fastest sustained rate of tum,
(b) sharpest sustained rate of turn, and (c) maximum load factor turn.
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：PERFORMANCE, STABILITY, DYNAMICS, AND CONTROL1(96)