曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

CAUTION: WHEN OPERATING THE WING FLAPS DURING LOW TEMPERATURES,
THE FLAP/STAB POSITION INDICATOR SHOULD BE MONITORED
CLOSELY FOR POSITIVE MOVEMENT. IF THE FLAPS/STAB SHOULD
STOP, THE FLAP CONTROL LEVER SHOULD BE PLACED IMMEDIATELY
IN THE SAME POSITION AS INDICATED.
To assure the airplane is configured for takeoff, complete the BEFORE TAKEOFF checklist.
TAKEOFF
For Advisory Data only (not FAA Approved), see GIV/OIS-2 for Takeoff and Landing from
Precipitation Covered Runways.
DO NOT use Reduced (FLEX) Thrust.
Do accomplish an engine run-up to as high thrust as possible and check for STABLE engine
operation BEFORE brake release.
Takeoff and accelerate-stop distances and V1 speeds are based on smooth, dry, hard surface
runways with no credit for reverse thrust. The stopping distance increases on slippery runways.
The minimum allowable V1 speed should be used.
GULFSTREAM AEROSPACE
GIV AIRPLANE FLIGHT MANUAL
ADVERSE WEATHER/ABNORMAL
ATMOSPHERIC CONDITIONS
APPENDIX E
E-12 FAA APPROVED
31 May 2001
Caution should be used for takeoffs on slippery runways with high crosswinds or when slush or
wet snow is present. During takeoff in slush, a slush and water bow wave forms in front of the
landing gear wheels, growing in size with increasing speed. The acceleration rate during the low
speed portion of the takeoff roll is about normal, but may deteriorate during the high speed
portion. Slush and/or water can accumulate on the leading edge and then freeze during climb.
Conditions permitting, the wing anti-ice should be turned on for takeoff. In addition, it is
possible to sustain damage on the lower fuselage and wing area from the slush thrown up from
the wheels.
When ready for takeoff, apply brakes and advance engine power levers. If the airplane starts to
slide on ice or snow during engine power check, release brakes and begin takeoff roll. During
takeoffs on icy runways, the lag in nose wheel steering must be realized and corrections must be
anticipated. A light, forward pressure on the control column will increase nose wheel steering
effectiveness.
Air Start Ignition selected ON for takeoff on runways with standing water, slush or snow.
After setting rated takeoff EPR, verify LP rpm and other engine indications are normal by 60 kts.
If the decision is made to reject the takeoff and the runway is slick, deploy ground spoilers, use
maximum reverse thrust and maximum anti-skid braking. Resist the temptation to release brakes
during anti-skid braking even if the ride is very rough. For directional control, use the rudder
primarily down to 50 Knots. The anti-skid system will provide the minimum stopping distance
for the existing condition of the runway.
If a loss of directional control develops, reduce reverse thrust to idle reverse. If sufficient runway
remains, return engines to forward thrust at low power, if necessary, to return to the runway
centerline. Use rudder pedal steering, if possible, for directional control. The nose steering
wheel, rudder and differential braking may also be used as necessary for directional control.
Rotate to normal takeoff attitude at VR - NOT BEFORE.
GULFSTREAM AEROSPACE
GIV AIRPLANE FLIGHT MANUAL
ADVERSE WEATHER/ABNORMAL
ATMOSPHERIC CONDITIONS
APPENDIX E
FAA APPROVED E-13
31 May 2001
AFTER TAKEOFF
Delay gear retraction if practical. This allows water, slush, and snow to be slung off as wheels
spin down.
If possible, cycling the gear once or twice may further reduce accumulations and will reduce the
possibility of gear door or brake freeze up.
Cowl/Wing anti-icing must be ON during flight operations when icing conditions exist or are
anticipated. When ASC 381 is installed and the "wing anti-ice" is ON, the warm exhaust air
from the wing anti-ice system is directed aft through the wheel well, across the wheels and then
vents overboard. Wheel and brake assemblies that were subjected to adverse weather conditions
prior to takeoff may benefit from the warm wheel well environment after gear retraction.
ICE AND ICING
It is recommended while flying in conditions that could cause icing, the autopilot be periodically
disengaged and the pilot hand fly the airplane to check airplane trim and flying qualities. When
flying in icing conditions, precise airspeed control is important. The recommended minimum
maneuvering speeds by flap settings are:
Flaps 0° - 200 KIAS Flaps 20° - 160 KIAS
Flaps 10° - 180 KIAS Flaps 39° - VREF +10 Kts
Large glaze ice formations which may develop on the empennage during takeoff or departure
may be shed by accelerating the airplane at low altitude to raise the airplane skin temperature
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：灣4飛機飛行手冊AFM Gulfstream IV AIRPLANE FLIGHT MANUAL 2(145)