曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

on the Audio Control Panel Control. Knob control is as follows:
• Left Inner Knob – On/Off power control and pilot ICS volume.
Full CCW is ‘OFF’ position (click).
• Left Outer Knob – Pilot ICS mic VOX level. CW rotation
increases the amount of mic audio (VOX level) required to
break squelch. Full CCW is the ‘hot mic’ position.
• Right Inner Knob – When pushed in, rotation controls copilot
ICS volume. When out, rotation controls passenger ICS
volume.
Revision 02: 07-18-05
P/N 13772-101 7 of 10
Cirrus Design Section 9
SR22 Supplements
• Right Outer Knob – Copilot and passenger mic VOX level. CW
rotation increases the amount of mic audio (VOX level) required
to break squelch. Full CCW is the ‘hot mic’ position.
Each microphone input has a dedicated VOX circuit to assure that only
the active microphone(s) is/are heard when squelch is broken. After
the operator has stopped talking, the intercom channel remains
momentarily open to avoid closure between words or normal pauses.
Control
The Audio Control Panel provides an adjustable Voice Operated Relay
(VOX) Squelch Control for the pilot, copilot, and passengers. Since the
VOX circuits reduce the number of microphones active at any one
time, the amount of unwanted background noise in the headphones is
diminished. This also allows the use of dissimilar headsets with the
same intercom. Because the user can adjust the trip level of the VOX
squelch to fit the individual voice and microphone, this helps eliminate
the frustration of clipping the first syllables. There is a slight delay after
a person stops talking before the channel closes. This prevents
closure between words and eliminates choppy communications.
To adjust squelch:
1. With the engine running, set the VOX trip level by slowly rotating
the SQL control knob clockwise until you no longer hear the
engine noise in the headphones.
2. Position microphone near your lips and speak into microphone.
Verify that normal speech levels open the channel.
Intercom Modes
The GMA 340 provides three intercom (ICS) modes to further simplify
workload and minimize distractions during all phases of flight: PILOT,
CREW, and ALL. The mode selection is accomplished using the
PILOT and CREW push-buttons. Pressing a button activates the
corresponding ICS mode and pressing the button a second time
deactivates the mode. The operator can switch modes (PILOT to
CREW or CREW to PILOT) by pressing the desired modes push-
Revision 02: 07-18-05
8 of 10 P/N 13772-101
Section 9 Cirrus Design
Supplements SR22
button. ALL mode is active when neither PILOT or CREW have been
selected.
The following table shows, in abbreviated form, what each occupant
hears in each of the selectable Intercom modes:
Marker Beacon
The Marker Beacon Receiver provides visual and audio indicators to
alert the pilot when the airplane passes over a 75 MHz transmitter.
PILOT The pilot is isolated from the intercom. The pilot can hear
radio and sidetone only during radio transmissions. Copilot
and passengers can hear the intercom and music but not the
airplane radio receptions or pilot transmissions.
CREW Pilot and copilot are connected on one intercom channel and
have exclusive access to the aircraft radios. They may also
listen to Music1. Passengers can continue to communicate
with themselves without interrupting the Crew and also may
listen to Music2.
ALL All parties will hear the aircraft radio, intercom, and Music1.
The music volume increases gradually back to the original
level after communications have been completed. Both pilot
and copilot have access to the COM transceivers.
Mode Pilot Hears Copilot Hears Passenger Hears
PILOT A/C Radios
Pilot
Passengers
Copilot
Music1
Passengers
Copilot
Music1
CREW A/C Radios
Pilot/Copilot
Music1
A/C Radios
Copilot/Pilot
Music1
Passengers
Music2
ALL A/C Radio
Pilot/Copilot
Passengers
Music1
A/C Radio Pilot/
Copilot
Passengers
Music1
A/C Radio
Pilot/Copilot
Passengers
Music1
Revision 02: 07-18-05
P/N 13772-101 9 of 10
Cirrus Design Section 9
SR22 Supplements
Marker beacon controls and lights are located at the extreme left of the
Audio Control Panel.
Marker beacon audio is selected by pressing the MKR push-button. If
no marker beacon signal is being received, pressing the MKR pushbutton
a second time deselects marker beacon audio. However, if
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：CIRRUS DESIGN SR22西銳22飛行員操作手冊和飛機飛行手冊(107)