曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

charged struts provide assistance in opening the doors and hold the
doors open against gusts. Front seat armrests are integrated with the
doors. A key lock in each door provides security. The cabin door keys
also fit the baggage compartment door lock. Separate keys are
provided for the fuel caps.
Revision A5
P/N 13772-001 7-35
Cirrus Design Section 7
SR22 Airplane Description
CABIN SPEAKER
EGRESS HAMMER
(IN ARMREST)
OVERHEAD LIGHT AND SWITCH
FIRE EXTINGUISHER
TIEDOWN LOOPS
(6 PLACES, AFT BULKHEAD)
TIEDOWN LOOPS
(4 PLACES, BAGGAGE FLOOR)
STALL WARNING HORN
DEFROST AIR OUTLETS
DOOR HANDLE
OVERHEAD LIGHT AND SWITCH
PASSENGER FRESH
AIR OUTLET
(UNDER PILOT'S SEAT)
SR22_FM07_1064
(OVERHEAD)
CAPS ACTIVATION T-HANDLE
DETAIL A
A
Figure 7-8
Cabin Arrangement
Revision A5
7-36 P/N 13772-001
Section 7 Cirrus Design
Airplane Description SR22
Baggage Compartment
The baggage compartment door, located on the left side of the
fuselage aft of the wing, allows entry to the baggage compartment.
The baggage door is hinged on the forward edge and latched on the
rear edge. The door is locked from the outside with a key lock. The
baggage compartment key will also open the cabin doors.
The baggage compartment extends from behind the rear passenger
seat to the aft cabin bulkhead. The rear seats can be folded forward to
provide additional baggage area for long or bulky items.
Four baggage tie-down straps are provided to secure baggage and
other items loaded in the baggage compartment. Each strap assembly
has a hook at each end and a cam-lock buckle in the middle. The hook
ends clip over loop fittings installed in the baggage floor and in the aft
bulkhead. The tie-down straps should be stowed attached and
tightened to the fittings. If not adequately restrained, baggage
compartment items may pose a projectile hazard to cabin occupants in
the event of rapid deceleration. Secure all baggage items with tiedown
straps.
To install tie-down strap:
1. Position straps over baggage. Thread straps through luggage
handles if possible.
2. Clip hook ends of straps over loop fittings.
3. Grasp the buckle and pull the loose strap end of each strap to
tighten straps over contents of baggage compartment.
To loosen tie-down straps:
1. Lift buckle release and pull on buckle to loosen strap.
2. Lift hook ends free of loop fittings.
Seats
The seating arrangement consists of two individually adjustable seats
for the pilot and front seat passenger and two individual seats with fold
down seat backs for the rear seat passengers.
The front seats are adjustable fore and aft and the seat backs can be
reclined for passenger comfort or folded forward for rear seat access.
Integral headrests are provided. The fore and aft travel path is
Revision A5
P/N 13772-001 7-37
Cirrus Design Section 7
SR22 Airplane Description
adjusted through the seat position control located below the forward
edge of the seat cushion. The seat track is angled upward for forward
travel so that shorter people will be positioned slightly higher as they
adjust the seat forward. Recline position is controlled through levers
located on each side of the seat backs. Depressing the recline release
control while there is no pressure on the seat back will return the seat
back to the full up position.
• Caution •
The seat bottoms have an integral aluminum honeycomb core
designed to crush under impact to absorb downward loads. To
avoid crushing this core, do not kneel or stand on the seats.
To position front seat fore and aft:
1. Lift the position control handle.
2. Slide the seat into position.
3. Release the handle and check that the seat is locked in place.
To adjust recline position:
1. Actuate and hold the seat back control lever.
2. Position the seat back to the desired angle.
3. Release the control lever.
Each rear seat consists of a fixed seat bottom, a folding seat back, and
a headrest. The seat backs can be unlatched from inside the baggage
compartment and folded forward to provide a semi-flat surface for
bulky cargo extending forward from the baggage compartment.
To fold seat back forward:
1. From the baggage access, lift the carpet panel at lower aft edge of
seat to reveal the seat back locking pins (attached to lanyards).
2. Remove the locking pins and fold seat forward.
Windshield and Windows
The windshield and side windows are manufactured of acrylic. Use
only clean soft cloths and mild detergent to clean acrylic surfaces.
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：CIRRUS DESIGN SR22西銳22飛行員操作手冊和飛機飛行手冊(67)