(b)
Jack up the aircraft and make the aircraft level (Ref. TASK 08-21-00-200-001).
(c)
Calculate the aircraft weight W: W = RA + RV W = aircraft weight RA = reaction that you measure at the forward jack point.
R EFF : 151-199, 301-399, 401-499, 08-10-00Page 610 Aug 01/05 CES NOTE : If you use platform scales, you must subtract the weight
____
of the jack.
RV = sum of the reactions that you measure at the wing jack
points.
NOTE : If you use platform scales, you must subtract the weight
____
of the jacks.
RC = Reference Chord
(d) Calculate the position of the center of gravity.
To do this, use the formula:
54.97 RV - 400.26 RA
CG (% RC) = -------------------W
(e) Lower the aircraft on its wheels (Ref. TASK 07-11-00-586-002).
(2)
Weigh the aircraft on its wheels and calculate the position of the center of gravity.
(a) Refer to the Weight and Balance Manual to weigh the aircraft and calculate the position of the center of gravity (Ref. WBM 1-80-04).
(3)
Weigh the aircraft on landing gear jacks and calculate the position of the center of gravity.
NOTE : You can do this procedure with load cells on each jack or with
____ platform scales under each jack. The load cells or the platform scales must have a capacity of:
-7000 daN min. at nose landing gear
-33400 daN min. at main landing gear
(a)
Put the jacks and the weighing devices in position.
(b)
Jack up the aircraft (Ref. TASK 07-11-00-582-003).
(c)
Refer to the Weight and Balance Manual to weigh the aircraft and calculate the position of the center of gravity (Ref. WBM 1-80-05).
R EFF : 301-399, 08-10-00Page 611 May 01/05 CES **ON A/C ALL
5. Close-up
________ Subtask 08-10-00-650-051
A. Refuel the Aircraft
(1) Refuel the aircraft after weighing (Ref. TASK 12-11-28-650-003) (Ref. TASK 12-11-28-650-004).
Subtask 08-10-00-710-050
B. Wet Motoring Check
(1) Do a wet motoring check (Ref. TASK 71-00-00-710-002). Subtask 08-10-00-584-051
C. Aircraft Towing
(1)
Tow the aircraft from the weighing area (Ref. TASK 09-10-00-584-001).
(2)
Make sure that the work area is clean and clear of tool(s) and other items.
EFF : ALL 08-10-00Page 612 May 01/05R CES
LEVELING - DESCRIPTION AND OPERATION
____________________________________
1. General
_______ This section provides information related to the leveling of the aircraft. It is divided as follows:
-QUICK LEVELING
-PRECISE LEVELING
EFF : ALL 08-20-00Page 1 Feb 01/98 CES
QUICK LEVELING - MAINTENANCE PRACTICES
______________________________________
R **ON A/C 001-049, 051-099, 101-105, 151-199, 201-213,
TASK 08-21-00-200-001
Quick Leveling Using the Attitude Monitor
1. Reason for the Job
__________________
There is an alternative method for this procedure. This task gives one of the methods. For the other method, refer to the other task in this Page Block.
2. Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------
REFERENCE QTY DESIGNATION
-------------------------------------------------------------------------------
No specific access platform 1.8 m (5 ft. 11 in.)
B. Referenced Information
-------------------------------------------------------------------------------
REFERENCE DESIGNATION
-------------------------------------------------------------------------------
07-11-00-581-001 Lifting for Aircraft Maintenance Operations 07-11-00-586-002 Lowering of the Aircraft for Maintenance Operations 08-21-00-991-001 Fig. 201
3. Job Set-up
__________
Subtask 08-21-00-010-050
A. Get Access 中國航空網(wǎng) www.k6050.com 航空翻譯 www.aviation.cn 本文鏈接地址：A320飛機(jī)維護(hù)手冊 AMM LEVELING & WEIGHING(5)
