曝光臺 注意防騙 網(wǎng)曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

_
 - do the BITE test of the landing gear (Ref. AMM TASK 32-69-00-740-001).
 a If the test gives a different maintenance message refer to
_ the Fault Symptom List.
 (b) If there is a ground signal:
 - replace the CONTROLLER-PACK 1 TEMP (7HH) (Ref. AMM TASK 21-61-34-000-001) and (Ref. AMM TASK 21-61-34-400-001).
R **ON A/C 401-499,
 E. If you cannot confirm this fault on the ground, but during the last flight a high PDT 1 (above 10 Deg.C) was reported:
 - replace the SENSOR-PRESS, PACK 1 INLET (23HB1) (Ref. AMM TASK 21-61-16-000-001) and (Ref. AMM TASK 21-61-16-400-002).
 (1) If the fault continues:
 - do a check for a ground signal at the ACSC1 (47HH) connector AB/2H (Ref. ASM 21-61/03).
 (a) If there is no ground signal:
 - do a check and repair the wiring if necessary between: ACSC1 (47HH) connector AB/2H and LGCIU 2 (5GA2) connector AB/1G (Ref. ASM 21-61/03).
 「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1 EFF : ALL ∞∞21-61-00∞∞∞∞∞∞∞∞∞∞Page A238
 Aug 01/05 CES a If the test gives a different maintenance message refer to

 1_ If the fault continues:
 - do the BITE test of the landing gear (Ref. AMM TASK 32-69-
00-740-001).

_ the Fault Symptom List.
 (b) If there is a ground signal:
 - replace the CONT-AIR COND SYSTEM 1 (47HH) (Ref. AMM TASK 21-61-34-000-002) and (Ref. AMM TASK 21-61-34-400-002).
 **ON A/C ALL
 F. Do the test as given in the Para. 3.A.
 5. Close-up
________
 A. Put the aircraft back to its initial configuration.
 「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1 EFF : ALL ∞∞21-61-00∞∞∞∞∞∞∞∞∞∞Page A239
 Aug 01/05R
 CES  TASK 21-61-00-810-833

 Pack 2 High Discharge Temperature
 1. Possible Causes
_______________
 - MACHINE-AIR CYCLE (11HM1)

 - SENSOR-WATER EXTRACTOR TEMPERATURE (31HH)

 - CONTROLLER-PACK 2 TEMP (27HH)

 - SENSOR-PACK OUTLET PNEUMATIC (11HM10)

 - VALVE-ANTI-ICE (37HH)

 - VALVE-FLOW CTL (8HB)

 - CONT-AIR COND SYSTEM 2 (57HH)

 - SENSOR-PACK INLET PRESSURE (36HH)

 - SENSOR-PRESS, PACK 2 INLET (24HB1)

 - ram-air inlet door mechanism

 - ram-air outlet

 - water injector nozzle

 - clogged main heat exchanger (11HM7)

 - clogged primary heat exchanger (11HM6)

 - wiring

 - clogged reheater (11HM3)

 - clogged condenser (11HM2)

 - water drain line

 - FLOW CONTROL SYSTEM (24HB)

 2. Job Set-up Information
______________________
 A. Referenced Information
 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
ASM 2161S02
 AMM 12-33-21-618-001 Pre-conditioning with the APU
 AMM 21-51-13-000-001 Removal of the Pack-Inlet Pressure Sensor 23HB1

 (24HB1) AMM 21-51-13-400-001 Installation of the Pack-Inlet Pressure Sensor 23HB1
 (24HB1) AMM 21-51-51-000-001 Removal of the Pack Flow-Control Valve AMM 21-51-51-400-001 Installation of the Pack Flow-Control Valve AMM 21-52-00-100-001 Cleaning of the Air Conditioning Pack-Primary Heat
 Exchanger 10HM6 (11HM6) and the Main Heat Exchanger 10HM7 (11HM7) AMM 21-52-00-100-002 Cleaning of the Air Conditioning Pack-Reheater 10HM3 (11HM3) AMM 21-52-00-100-003 Cleaning of the Air Conditioning Pack-Condensor 10HM2
 (11HM2) AMM 21-52-00-780-001 Pressure Drop Test of the Reheater 10HM3 (11HM3) AMM 21-52-00-960-001 Replacement of the Water Injector Nozzle AMM 21-52-16-000-001 Removal of the Water Extractor 10HM8 (11HM8)
 「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1R EFF : ALL ∞∞21-61-00∞∞∞∞∞∞∞∞∞∞Page A240
 Aug 01/05 CES -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------

AMM  21-52-16-400-001 
AMM  21-52-21-000-001 
AMM  21-52-21-400-001 
AMM  21-52-42-000-001 
AMM  21-52-42-400-001 
AMM  21-61-13-000-001 
AMM  21-61-13-400-001 
AMM  21-61-16-000-001 
AMM  21-61-16-400-002 
　
中國航空網(wǎng) www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320 Trouble Shooting Manual 排故手冊 AIR CONDITIONING 空調(diào)2(63)