- during the test monitor the SEAT-MOUNTED EMERGENCY LIGHT (800WL) on the related LH seat rows (Ref. ASM 33-51/04).
- replace the related SEAT-MOUNTED EMERGENCY LIGHT (800WL) (Ref. AMM TASK 33-51-19-000-001) and (Ref. AMM TASK 33-51-19-400-001) if not illuminated (Ref. ASM 33-51/04).
(a) If the fault continues:
- do a check and repair the wiring between: the related lamp module 800WL pin 3 and EPSU 13WL pin -J (or pin -B).
「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1R EFF : 106-149, 301-399, 401-499, ∞∞33-51-00∞∞∞∞∞∞∞∞∞∞Page A249
Aug 01/05 CES the related lamp module 800WL pin 1 and GND (Ref. ASM 33-51/04).
C. Do the test given in para. 3.
5. Close-up________
A. Put the aircraft back to its initial configuration.
TASK 33-51-00-810-843
Failure of the Crossaisle Lights (Floor Proximity Emergency Escape Path Marking System) controlled by EPSU 11WL
1. Possible Causes
_______________
- WALL-MOUNTED EMERGENCY-EXIT-MARKER (90WL3)
- wiring
2. Job Set-up Information
______________________
A. Referenced Information
-------------------------------------------------------------------------------
REFERENCE DESIGNATION
-------------------------------------------------------------------------------
AMM 33-51-00-710-010 Operational Test of the Emergency Lights via MCDU AMM 33-51-13-000-001 Removal of the Cabin Wall-Mounted Emergency-Exit-Markers AMM 33-51-13-400-001 Installation of the Cabin Wall-Mounted Emergency-Exit-Markers ASM 33-51/04
3. Fault Confirmation
__________________
A. Do the operational test of the emergency lights via MCDU (Ref. AMM TASK 33-51-00-710-010).
4. Fault Isolation
_______________
A. If the test gives a different maintenance message, do the trouble shooting procedure related to the maintenance message.
B. If the operational test gives the maintenance message:
(1) FPEEPMS CROSSAISLE LT/EPSU(11WL)EMER L:
- replace the WALL-MOUNTED EMERGENCY-EXIT-MARKER (90WL3) (Ref. AMM TASK 33-51-13-000-001) and (Ref. AMM TASK 33-51-13-400-001) if not illuminated.
(a) If the fault continues:
- do a check and repair the wiring between: lamp module 90WL3 pin 3 and EPSU 11WL pin -H. lamp module 90WL3 pin 1 and GND (Ref. ASM 33-51/04).
C. Do the test given in para. 3.
5. Close-up
________
A. Put the aircraft back to its initial configuration.
「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1R EFF : 106-149, 301-399, 401-499, ∞∞33-51-00∞∞∞∞∞∞∞∞∞∞Page A251
Aug 01/05 CES
TASK 33-51-00-810-844
Failure of the Crossaisle Lights (Floor Proximity Emergency Escape Path Marking System) controlled by EPSU 12WL
1. Possible Causes
_______________
- WALL-MOUNTED EMERGENCY-EXIT-MARKER (90WL4)
- wiring
2. Job Set-up Information
______________________
A. Referenced Information
-------------------------------------------------------------------------------
REFERENCE DESIGNATION
-------------------------------------------------------------------------------
AMM 33-51-00-710-010 Operational Test of the Emergency Lights via MCDU AMM 33-51-13-000-001 Removal of the Cabin Wall-Mounted Emergency-Exit-Markers AMM 33-51-13-400-001 Installation of the Cabin Wall-Mounted Emergency-Exit-Markers ASM 33-51/04
3. Fault Confirmation
__________________
A. Do the operational test of the emergency lights via MCDU (Ref. AMM TASK 33-51-00-710-010).
中國航空網(wǎng) www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320 Trouble Shooting Manual 排故手冊 LIGHTS 燈光(135)
