of the Emergency Exits ASM 33-51/01 ASM 33-51/02 ASM 33-51/02 AWM 33-51-04 AWM 33-51-04 AWM 33-51-04
3. Fault Confirmation
__________________
A. Do the operational test of the emergency lighting system (Ref. AMM TASK 33-51-00-710-001).
4. Fault Isolation
_______________
A. If the test gives a different maintenance message, do the trouble
shooting procedure related to the maintenance message.
**ON A/C 001-003, 051-052,
B. If the operational test gives the maintenance message:
EPSU EXT LOAD FWD L:
- do the operational test of the emergency lights not with CIDS (Ref. AMM TASK 33-51-00-710-006).
(1) If the green LED 'OK EXTERNAL LOADS' comes on:
- replace the POWER SUPPLY UNIT-EMERGENCY (10WL) (Ref. AMM TASK 33-51-38-000-001) and (Ref. AMM TASK 33-51-38-400-001).
(2) If the red LED 'FAULT EXTERNAL LOADS' comes on and a correct adapter cable between the escape slide and the aircraft electrical connector is available:
NOTE : A fault in one of the two forward escape slides can cause the
____
LED to come on.
NOTE : For tests, use one of the items of equipment that follows:
____
- A connector with four lamps (6V, 0.2 amps) in parallel
- A connector with a 7.5 ohm, 5 watt resistor
- A serviceable escape slide.
「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1 EFF : 001-049, 051-099, 101-105, 151-199, ∞∞33-51-00∞∞∞∞∞∞∞∞∞∞Page 252
201-299, Aug 01/05R
CES
(a) Do the subsequent procedures:
- remove the ESCAPE SLIDE FWD L (7500MM) as necessary to get access to the electrical connector (Ref. AMM TASK 25-62-44-000-002).
- connect a serviceable escape slide with the adapter cable to the aircraft.
(b) If the fault does no longer exist:
- remove the old ESCAPE SLIDE FWD L (7500MM) fully (Ref. AMM TASK 25-62-44-000-002).
- install the serviceable escape slide (Ref. AMM TASK 25-62-44-400-001).
(c) If the fault continues:
- connect the ESCAPE SLIDE FWD L (7500MM) electrically only.
- remove the ESCAPE SLIDE FWD R (7501MM) as necessary to get access to the electrical connector (Ref. AMM TASK 25-62-44-000-002).
- connect a serviceable escape slide with the adapter cable to the aircraft.
(d) If the fault does no longer exist:
- remove the old ESCAPE SLIDE FWD R (7501MM) fully (Ref. AMM TASK 25-62-44-000-002).
- install the serviceable escape slide (Ref. AMM TASK 25-62-44-400-001).
- install the old ESCAPE SLIDE FWD L (7500MM) (Ref. AMM TASK 25-62-44-000-001).
(e) If the fault continues:
- do a check and repair the wiring between: escape slide connector 2870VC pin A and EPSU (10WL) pin F, escape slide connector 2870VC pin B and GND, PROX SW-HANDLE, R FWD ESC SLIDE (4WN2) pin E and EPSU (10WL) pin S, PROX SW-HANDLE, R FWD ESC SLIDE (4WN2) pin F and GND, PROX SW-HANDLE, R FWD PAX/CREW DOOR (13WV2) pin E and EPSU (10WL) pin <K, PROX SW-HANDLE, R FWD PAX/CREW DOOR (13WV2) pin F and GND (Ref. ASM 33-51/01) and (Ref. AWM 33-51-04).
(f) If the fault does no longer exist:
- install the old ESCAPE SLIDE FWD R (7501MM) (Ref. AMM TASK 25-62-44-400-001).
- install the old ESCAPE SLIDE FWD L (7500MM) (Ref. AMM TASK 25-62-44-000-001).
(g) If the fault continues:
- do a check and repair the wiring between: escape slide connector 2871VC pin A and EPSU (10WL) pin T, escape slide connector 2871VC pin B and GND,
「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1R EFF : 001-003, 051-052, ∞∞33-51-00∞∞∞∞∞∞∞∞∞∞Page 253
May 01/05 CES
PROX SW-HANDLE, L FWD ESC SLIDE (4WN1) pin E and EPSU (10WL)
pin C,
PROX SW-HANDLE, L FWD ESC SLIDE (4WN1) pin F and GND,
PROX SW-HANDLE, L FWD PAX/CREW DOOR (13WV1) pin E and EPSU
(10WL) pin D,
PROX SW-HANDLE, L FWD PAX/CREW DOOR (13WV1) pin F and GND
(Ref. ASM 33-51/01) and (Ref. AWM 33-51-04).
- install the old ESCAPE SLIDE FWD L (7500MM) (Ref. AMM TASK 25-62-44-400-001).
- install the old ESCAPE SLIDE FWD R (7501MM) (Ref. AMM TASK 25-62-44-400-001).
(h) If the fault continues:
- replace the PROX SW-HANDLE, L FWD ESC SLIDE (4WN1) (Ref. AMM TASK 52-73-11-000-001) and (Ref. AMM TASK 52-73-11-400-001).
(i) If the fault continues: 中國航空網 www.k6050.com 航空翻譯 www.aviation.cn 本文鏈接地址：A320 Trouble Shooting Manual 排故手冊 LIGHTS 燈光(99)
