38-32-68
 ú ú 01 Page 402 ú Jun 10/94
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
C82105
A
747-400 MAINTENANCE MANUAL
 S 034-009
 (8)  
Separate the sensor shroud from the sensor.

 S 034-010

 (9)  
Remove and discard the two gaskets.

 S 144-011

 (10)
 If it is necessary, clean the sensor shroud with hot soapy water and a nonmetallic stiff-bristle brush.

 TASK 38-32-68-404-016
 3. Fluid Level Sensor Installation (Fig. 401)
_______________________________
 A. Reference
 (1)  AMM 24-22-00/201, Manual Control
 B. Access
 (1)  Location Zone 224 Upper Deck Crew Rest Body Sta 385 to 632, Right
 C. Procedure
 S 424-017
 (1)  
Put a new gasket in its position on the toilet tank.

 S 864-018

 (2)  
Loosely assemble the sensor and the sensor shroud between a new gasket.

 S 424-019

 (3)  
Put the sensor and the sensor shroud in their installed position on the toilet tank.

 NOTE: The top view of the toilet tank in Fig. 401 gives the correct
____
 position.

 S 434-020
 (4)  
Install the washers and nuts.

 (5)  
Connect the electrical connector to the sensor.

 S 864-021
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. FREIGHTERS ú

 38-32-68
 ú ú 01 Page 403 ú Oct 10/94
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
 S 864-022
 (6)  Remove the DO-NOT-CLOSE tag and close this circuit breaker on P414
 Power Distribution Panel - Left.
 (a)  414F23 FILL CONTROL LAV TANK
 S 864-023
 (7)  Supply electrical power (AMM 24-22-00/201).
 S 864-024
 (8)  Use the rinse fitting at the service panel to fill the toilet tank
 with water until you can see the water come into the toilet bowl or
 until it stops automatically.
 NOTE:____ If the water comes into the toilet bowl, the fill control
 system does not operate correctly.
 S 864-025
 (9)  Push in the outlet side of the hinged separator in the toilet bowl
 to view its contents.
 S 714-026

 (10)
 Make sure that the level of the water is approximately 3 inches below the lower surface of the top of the toilet tank.

 S 414-027

 (11)
 Carefully put the toilet shroud over the toilet tank assembly and engage the latches.

 S 614-029

 (12)
 Do the steps in AMM 12-17-61/301 to drain the water from the toilet tank and add the chemical precharge.

 S 864-028

 (13)
 Remove the electrical power if it is not necessary (AMM 24-22-00/201).

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. FREIGHTERS ú

 38-32-68
 ú ú 01 Page 404 ú Oct 10/93
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
 WASTE DRAIN VALVE ASSEMBLY - REMOVAL/INSTALLATION
_________________________________________________
 1. General
_______
 A. This procedure has these tasks:
 (1)  
Remove the waste drain valve at the service panel.

 (2)  
Install the waste drain valve at the service panel.

 TASK 38-32-69-004-001
 2. Waste Drain Valve Removal (Fig. 401)
_________________________
 A. References
 (1)  
AMM 12-17-61/301, Waste Tank Servicing

 (2)  
AMM 30-71-05/401, Waste Tank Drain Fitting Gasket Heater.

 B. Access
 (1)  
Location Zone 124 Area Below Forward Cargo Container Compartment, Right

 (2)  
Access Panels
 125A Waste Tank Service Panel

 C. Procedure
 S 024-002
 (1)  
Open the service panel door for the toilet waste tank.
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747-400 AMM 飛機維護手冊 氣動系統 WATER/WASTE(73)