EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. AIRPLANES WITH SYSTRON DONNER FIRE ú

 26-15-02
 DETECTORS  ú
 ú 03 ú BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.  Page 402Jan 20/98 

A

757
MAINTENANCE MANUAL

UPPER FIRE DETECTOR
A
QUICK-RELEASE
CLAMP
SEE A

LOWER FIRE DETECTOR
4. BUSHING
A
SUPPORT TUBE
5. CLIP-P
1. DETECTOR ELEMENT
2. WASHER-TAB
RETAINING NUT
END BRACKET
ELECTRICAL CONNECTOR LOCKWIRE
3. WASHER-SEALING COPPER (4 LOCATIONS)
APU FIRE DETECTOR
TIGHTEN CONNECTION
AIRPLANE WIRING
BUSHING DETECTOR
(2 LOCATIONS)
ELEMENT
(2 LOCATIONS)

A
ELECTRICAL
B
LOCKWIRECONNECTOR
QUICK-RELEASE
CLAMP

A A-A
APU Fire Detector Element Installation
Figure 401 (Sheet 2)

EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. AIRPLANES WITH GRAVINER FIRE DETECTORS ú

 26-15-02
 ú ú 07 Page 403 ú Jun 20/95
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A72145
A

757
MAINTENANCE MANUAL

 C.  Access (1) Location Zones 119/120 Main Equipment Center 211/212 Flight Compartment 310 Fuselage
 (2)  Access Panels 311/312 313/314 315/316  Area Aft of Pressure Bulkhead to BS 1725 (L, R)Stabilizer Torsion Box Compartment (L, R)APU Compartment
 D.  Remove the APU Fire Detector Element
 (1)  S 864-001Open these circuit breakers on the overhead circuit breaker panel, P11, and attach DO-NOT-CLOSE tags: (a) 11B24, FIRE DETECTION APU 1
 E.  S 014-002 (2) Open the APU access doors and install rods to hold the doors open.AIRPLANES WITH SYSTRON DONNER FIRE DETECTORS; Remove the detector element
 (1)  S 034-003Remove the four bolts (2) to remove the two clamps (4) on the detector responder (1).
 (2)  S 034-004Disconnect the electrical connector and install a protective cap.
 F.  S 034-005 (3) Open the quick-release clamps (10) to remove the detector element (9).AIRPLANES WITH GRAVINER FIRE DETECTORS; Remove the detector element
 (1)  S 034-006Disconnect the electrical connectors at each end of the detector element to be removed and install protective caps. Discard copper crush washers.

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 26-15-02
 ALL  ú ú 04 Page 404 ú May 28/99
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A

757 MAINTENANCE MANUAL
 S 034-007
 (2)  
Remove the retaining nut which holds the detector element connector to the end bracket of the support tube at each end of the detector.

 S 034-008

 (3)  
Remove the connector from the end brackets.

 S 024-009

 (4)
Open the quick-release clamps and remove the detector element.

 TASK 26-15-02-424-010
 3.  Install the APU Fire Detector Element (Fig. 401)
_____________________________________
 A.  References
 (1)  AMM 24-22-00/201, Electrical Power - Control
 B.  Equipment
 (1)  Torque Wrench - commercially available
 C.  Access
 (1)  
Location Zones
 119/120 Main Equipment Center
 211/212 Flight Compartment
 310 Fuselage

 (2)  
Access Panels 311/312 Area Aft of Pressure Bulkhead to BS 1725 (L, R) 313/314 Stabilizer Torsion Box Compartment (L, R) 315/316 APU Compartment

 D.  AIRPLANES WITH SYSTRON DONNER FIRE DETECTORS;
 Install the detector element

 S 434-011
 (1)  Install the responder (1) with the two clamps (4), and four bolts (2), washers (3), and nuts (7).
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：757 AMM 飛機維護手冊 防火 FIRE PROTECTION 1(69)