VALVE SPRINGS
OIL RELIEF VALVE
FUEL DRAIN CHECK VALVE
OIL PRESSURE RELIEF VALVE
Engine Springs and Hardware
2-30
SERVICE TABLE OF LIMITS
PART III GEARED ENGINES
CHART MODELS
E GO-435 ALL
E1 GO435-C2B2, -C2B2-6
H GO480, IGO-480 ALL
H1 GO-480-B
H2 GO-480-F1A6, -F2A6, -F4A6, -G2D6, -G2F6
H3 GO-480-G1H6, -G1D6
H4 H5 P GO-480-D1A (Crosswise Accessory Housing) GO-480-G1B6 (Crosswise Accessory Housing) GSO-480, IGSO-480
P1 IGSO-480
AB IGSO-540
AC IGO-540
NOTE
In "Chart" column, a number appearing after a letter shows exception to basic model.
SECTION I 500 SERIES CRANKCASE, CRANKSHAFT & CAMSHAFT
SECTION II 600 SERIES CYLINDERS
SECTION III 700 & 7000 SERIES GEAR TRAIN
SECTION IV 800 SERIES BACKLASH (GEAR TRAIN)
SECTION V 900 SERIES TORQUE & SPRINGS
(A) These fits are either shrink fits controlled by machining, fits that mayreadily be adjusted, or fits where wear does not normally occur. In each
case, the fit must be held to manufacturing tolerance.
(B) Side clearance with piston. on piston rings must be measured with face of ring flush
(C) Replacements to correct these items must be made to give uniform backlash within 0.001 between the stationary gear and pinions, and within 0.001 between the pinions and the ring gear.
(D) These dimensions shown angles to piston pin. are measured at bottom of piston skirt at right
(E) Permissible wear of the crankshaft (rod and main bearing journals) to
be minus 0.0015 on the diameter.
(L) Loose fit; wherein surfaces. a definite clearance is mentioned between the mating
(T) Tight fit; shrink or interference fit.
SSP1776
January 31, 1980*
* -Indicates cut-off date for data retrieved prior to publication.
SERVICE TABLE OF LIMITS
PART III GEARED ENGINES
SECTION I CRANKCASE, CRANKSHAFT, CAMSHAFT
Ref. Ref. Chart Nomenclature Dimensions Clearances
Mfr. Mfr.
New Old Min. Serv. Min. Serv.
& Max. & Max.
Max. Max.
500 501 E-H1-H2-H4 All Main Bearings and .0015L
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：Lycoming SERVICE TABLE OF LIMITS AND TORQUE VALUE RECOMMENDATIONS(32)
