PW4000 SERIES ENGINES

777 AIRCRAFT MAINTENANCE MANUAL

THIS PAGE IS INTENTIONALLY LEFT BLANK

76-00-00

Page 18 D633W101-BEJ Sep 05/2002

ENGINE CONTROLS -OPERATION

Controls
You use many flight deck controls and displays with the engine controls system to operate the engine. These are the controls and displays and the ATA chapters where you find the details on them:
*
Thrust levers (76)

*
Fuel control switches (76)

*
EEC maintenance switches (73)

*
EEC mode switches (73)

*
Start/Ignition switches (74,80)

*
Autostart switch (80)

*
Fire switches (26)

*
EICAS display (77)

*
Multi-function display (MFD) (73,75,76,77,78,79,80).

Thrust Lever (76)
Each thrust lever mechanically moves its TLA resolver. The resolver sends the EEC a signal in proportion to the angular position of the thrust lever. This permits the EEC to set the proper thrust.
Fuel Control Switch (76)
Each fuel control switch has two positions; RUN and CUTOFF. In RUN, the switch signals the EEC to turn on fuel. The EEC makes the decision when to turn on fuel. In CUTOFF, the switch controls the FMU to shut off metered fuel flow to the injectors. It also makes the engine fuel spar valve close. See chapter 28 for more information on the engine spar valve.
EFFECTIVITY
BEJ ALL

In addition, when you move the fuel control switch from RUN to CUTOFF, the EEC resets. This stops the software programs in the EEC and sets them to run from the start.
EEC Maintenance Switch (73)
Each EEC maintenance switch has two positions; NORM and TEST. In NORM, the switch lets EEC power come from normal operating power sources. In TEST, the switch connects airplane ac power to the EEC without starting any EEC control logic.
EEC Mode Switch (73)
Each EEC mode switch lets the pilots set the EEC control mode: normal (EPR) or alternate (N1). You should always operate both engines in the same control mode.
Start/Ignition Switches (74,80)
You use the start/ignition switch to begin the start of the engine. It also lets you select continuous ignition on the engine.
Autostart Switch (80)
The autostart switch permits the EEC to automatically control engine starts.
76-00-00

Page 19 D633W101-BEJ Sep 05/2002

ENGINE CONTROLS -OPERATION

Fire Switch (26)
The fire switch permits FMU control power to go to the engine relay unit (ERU) when the switch is in its normal position (in). If the switch is pulled out, power connects directly to the FMU cutoff solenoid to stop metered fuel flow to the injectors. engine. It also makes the engine fuel spar valve close. See chapter 28 for more information on engine spar valve operation.
EICAS Display (77)
The EICAS display shows the primary engine indications. These are EPR, N1, and EGT.
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：777 AMM 飛機維護手冊 發動機控制 Engine Control PW 777 AIRCRAFT MAINTENANCE MANUAL(6)