(4)  
AMM 32-00-15/201, Landing Gear Door Locks

 B.
Access

 (1)  
Location Zones
 133 Wing Center Section (Left)
 134 Wing Center Section (Right)

 C.
Procedure

 (1)  
Put a washer on each screw.

 (2)  
Put the screws through the actuator flange.

 (3)  
Put a second washer on each screw.

 S 434-011
 S 434-024
 S 434-025
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 28-25-11
 ALL  ú ú 01 Page 403 ú May 28/99

A

757
MAINTENANCE MANUAL

 (4)  S 864-012Move the manual override handle of the actuator to the CLOSED position.
 (5)  S 424-013Align the actuator with the bolts on the rear spar.
 (6)  S 214-026Make sure the teeth on the splined shaft of the actuator align with the shaft in the valve body.
 (7)  S 424-027Install the screws into the bolts.
 (8)  S 434-028Install the lockwire on the screws (AMM 20-10-23/401).
 (9)  S 434-014Attach the bonding jumper to the actuator below the electrical connector.
 S 224-015

 (10)
 Make sure the bonding resistance between the APU fuel shutoff valve and the airplane structure is not more than 0.005 ohms (AMM 20-10-21/601).

 S 434-016

 (11)
 Connect the electrical connector to the actuator.

 S 864-029

 (12)
 Remove the DO-NOT-CLOSE tag and close this circuit breaker on the P6 panel:

 (a)
6E3, FUEL VALVES APU

 S 864-017
 (13) Supply electrical power (AMM 24-22-00/201).
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 28-25-11
 ALL  ú ú 01 Page 404 ú Sep 28/00

A

757
MAINTENANCE MANUAL

 S 094-032
 WARNING: USE THE PROCEDURE IN AMM 32-00-15/201 TO REMOVE THE DOOR LOCKS.
_______ THE DOORS OPEN AND CLOSE QUICKLY AND CAN CAUSE INJURY TO PERSONS OR DAMAGE TO EQUIPMENT.
 (14)
 Remove the door locks from the landing gear doors and close the doors (AMM 32-00-15/201).

 S 864-030

 (15)
 Open this circuit breaker on the main power distribution panel, P6, and attach a DO-NOT-CLOSE tag:
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：757 AMM 飛機維護手冊 燃油 CHAPTER 28 - FUEL 4(58)