曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

- Rilsan scraper
- Hard rubber roller
- Drip pan
- Polyethylene van
- "SPONTEX" sponge or a big model equivalent one
- Sewing needle
- Clean lintfree cloths
- C gasoline (TB 11-918) or F gasoline (TB 11-919)
- Methyl-Ethyl-Ketone (M.E.K.) (TB 11-003)
NOTE : Transfers are of different manufacturing : "BSB" - see detail A, or "DISA" - see detail B, as well as polycarbonate grey self-adhesives - see detail C, or transparent tapes ("3M", "SCOTCHCALL" types, and so on) - see detail D.
For positioning of "BSB" transfers, use Special C decal solvent (TB 07-903) and C decal solvent (TB 07-904).
For positioning of "DISA" transfers, use 527 B "DISA" decal solvent (TB 07-905).
Transfers and self-adhesives
Figure 201
AAAA
Validity : S / N 1 - 9999 20-00-05Page 201
(BA) DEC 98
 
C. Positioning of "BSB" transfers (Figure 202)
1) Sequences of operations
Area preparation :
a) Mark the place of transfers to be positioned.
b) Carefully clean area with a C gasoline (TB 11-918) or F gasoline (TB 11-919) soaked cloth.
c) Impregnate the area with a sponge soaked with special C decal solvent (TB 07-903).
NOTE : In case of decal solvent overflowings or runnings, immediately clean with pure water.
2) Work on the aircraft
Before positioning the transfers on the aircraft, plunge transfers during 15 to 20 seconds in the following mixture :
— C decal solvent (TB 07-904) : 1 volume
— Tepid water [30 to 40°C (86 to 104°F)] : 1 volume NOTE : Use a new prepared mixture for each aircraft.
3) Positioning
a) Fit the transfer over the foreseen exact position with letter marks facing the aircraft area.
b) With hand, put one of the edges in contact with the area and hold the other transfer edge stretching it lightly to avoid folds.
c) With regard to the coordinates indicated on the support paper, complete their vertical and horizontal positionings.
 

 
Positioning of "BSB" transfers
Figure 202 (1/3)
 
d) Put the transfer in contact with the application area using a plastic scraper or an applying roller.
 

 
Positioning of "BSB" transfers
Figure 202 (2/3)
e) Flatten by firmly pressing on the scraper, by successive passages overlaying themselves, the transfer part to be applied and check it for no air bubbles and folds and for its good adhesion.
Wipe water runnings with a sponge, as the work proceeds.
f) Wait two minutes and remove the support paper.
NOTE : In spite of taken precautions, should air bubbles confined between the film and the application area appear, perforate these bubbles with a needle, and press with the nail or with a plastic scraper to drive the air out.
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：TB20 MAINTENANCE MANUAL 20 STANDARD PRACTICES AIRFRAME TB20飛機維護手冊 20 標準施工機體(42)