曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

- Siccative oil (TB 05-914)
- Cleaning agent (TB 11-003)
- Clean lintfree cloths
- Drip pan
- Blanking plugs
- Syringe
- Protecting goggles and gloves
B. Procedure for a tube with one (or both) end(s) open
1) If both tube ends are open, blank off one end.
WARNING : USE PROTECTING GOGGLES AND GLOVES.
2) Prepare linseed oil and siccative mixture with the following proportions :
- quantity of linseed oil necessary to fill up the tube completely + 10 % of siccative in mass.
3) Fill up the tube completely with siccative oil (TB 05-914) through the orifice.
4) Empty the tube into a drip pan and allow it to drip for 24 hours, which is the time necessary for the formation of the protection film.
5) If installed, remove the blanking plug.
6) Clean the tube outer surfaces with a clean lintfree cloth moistened with cleaning agent (TB 11-003).
C. Procedure for a tube with both ends closed (engine mount or landing gear mount)
1) Calculate the volume of the tube according to its length and inner diameter.
NOTE : The quantity of siccative oil (TB 05-914) required is 8 % of the tube volume. WARNING : USE PROTECTING GOGGLES AND GLOVES.
2) Prepare linseed oil and siccative mixture with the following proportions :
- quantity of linseed oil required + 10 % of siccative in mass.
3) Using a syringe, inject siccative oil (TB 05-914) into the tube and blank off breather hole, either with a blind rivet or a sticky patch.
NOTE : Blind rivets are used to blank off tube holes whereas sticky patches are used to blank off mount plate holes.
WA
Validity : S / N 1 - 9999 20-00 16Page 301
(BA) JUN 02
 
CAUTION : CORROSION RESISTANCE OF TREATED COMPONENTS WILL DEPEND ON WHETHER THIS PROCEDURE HAS BEEN APPLIED CORRECTLY.
4) Shake the engine mount or landing gear mount so as to cover the tube whole inner surface.
5) Clean the tube outer surfaces with a clean lintfree cloth moistened with cleaning agent (TB 11-003).
AAAA
Validity : S / N 1 - 9999 20-00-16 (BA) Page 302
JUN 02
 
LIST OF MATERIALS
DESCRIPTION AND OPERATION
WARNING : BE CAREFUL WHEN YOU USE CONSUMABLE MATERIALS. OBEY THE OPERATOR'S AND MANUFACTURER'S HEALTH AND SAFETY DATA SHEETS.
1. GENERAL
This topic groups all materials used for maintenance operations described in the Maintenance Manual.
These materials are classified according to their type and are defined by catalogs, technical regulations, national specifications, manufacturer's drawings or publications.
They are classified by category as follows :
01 - Fuels
02 - Hydraulic fluids
03 - Oils
04 - Greases
05 - Special materials
06 - Lubricants
07 - Lacquers
08 - Adhesive materials
09 - Sealants
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：TB20 MAINTENANCE MANUAL 20 STANDARD PRACTICES AIRFRAME TB20飛機維護手冊 20 標準施工機體(57)