曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

14) Install protection box (10) of condenser hose.
15) Make sure all the tools and materials are removed and the work area is clean and free from debris.
16) Remove the warning sign prohibiting main switch-breaker operation.
17) Install baggage compartment bottom door 242, the towing bar and the protection net.
18) Install A65 emergency locator transmitter - refer to 25-61-01.
 
19) Close the baggage compartment door.
20) Perform an operational test of the vapor cycle cooling system - refer to 21-55-00, page 501.
 

  1 - Inspection door 245
2 - Central panel
3 - Screw
4 - Inspection door 247
5 - Evaporator
6 - Nut
7 - Lockwasher
8 - Washer
9 - Pin
10 - Protection box
11 - Inspection door 246
 
10
B61 condenser fan - Removal / Installation
Figure 202
 

  21 - Bolt
22 - Washer
23 - Nut
24 - Condenser fan
25 - Bolt
26 - Washer
27 - Nut
28 - Adapter
29 - Air discharge hose
30 - Support
31 - Bolt
32 - Washer
33 - Riveted support
34 - Receiver drier
B61 condenser fan - Removal / Installation
Figure 203
AAAA
Validity : KEITH 21 _55-02Page 207
(BA) AUG 01
 
PAGE INTENTIONALLY LEFT BLANK
 
EVAPORATOR
MAINTENANCE PRACTICES
1. SERVICING None
2. REMOVAL / INSTALLATION - EVAPORATOR (Figures 201 and 202)
A. Tools and consumable materials
Blanking caps and plugs
- Tie-wraps
- Sealant (TB 09-904)
- Sealant (TB 09-909) Loctite (TB 08-013C) Sealant (TB 09-905)
- Red paint
- Vacuum cleaner
B. Removal of the evaporator
1) Install the warning sign prohibiting main switch-breaker operation.
WARNING
DO NOT OPERATE
MAINTENANCE WORK IN PROGRESS
2) Open baggage compartment door, remove towing bar and baggage compartment bottom door 242.
NOTE : In the case of the oxygen installation, remove the baggage compartment lower bottom door.
3) Remove the protection net.
4) Drain the refrigerant - refer to 12-15-02.
5) Remove A65 emergency locator transmitter - refer to 25-61-01.
6) Remove the screws securing inspection door 245 (1) and inspection door 247 (3). Do not remove the three screws (2).
NOTE : One of screws (2) is not easily accessible. It is therefore preferable to remove both doors secured to each other.
7) Clear and remove both doors.
8) Disconnect the HP and LP hoses from evaporator (5), blank off.
9) Disconnect the terminals of S86 thermostat (30) (if installed).
WA
Validity : KEITH 21 55 03Page 201
(BA) AUG 01
 
10) Remove clamp (4) securing the air hose.
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：TB20 MAINTENANCE MANUAL 21 AIR CONDITIONING TB20飛機維護手冊 21 空調(32)