曝光臺 注意防騙 網(wǎng)曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

(standard) or kilograms (optional). The primary EICAS page displays fuel quantity in
all fuel tanks, and total fuel in the airplane.
YD OFF
GLD MANU
PARK/EME
<– FUEL
TOTAL FUEL (LBS) 4155O
1.54
146OO 1OOOO 146OO
N2
FF (PPH)
OIL TEMP
OIL PRESS
93.4
575O
115
81
SPD
EPR
I
G
N
START START
I
G
N
ND
STAB
1.54
73.3
T/O
N1
SYNC
73.3
789
ITT
SYNC
789 DN D
G
–TR
NL
LWD
7.2
NU
93.4
575O
115
81
235O
Fuel Flow Readout
Indicates fuel flow in pounds per
hour (PPH) to the respective
engine.
Fuel Quantity Readout
(Wing Tank)
Green
Amber
Indicates fuel quantity in the
respective wing tank, in
pounds (lbs).
• – Left and right tanks
are balanced.
• – A fuel quantity
imbalance exists.
Total Fuel Readout
Green
Amber
Indicates total fuel quantity in
pounds (lbs), of all the tanks.
• – Total fuel quantity is
valid and in normal range.
• – A fuel low quantity or
discrepancy exists.
Fuel Quantity Readout
(Aft Tank)
Green
Amber
Indicates fuel quantity in the
aft tank, in pounds (lbs).
• – Quantity is valid.
• – A fuel quantity
discrepancy exists.
Fuel Quantity Readout
(Center Fuselage Tank)
Green
Amber
Indicates fuel quantity in the
cente tank, in pounds (lbs).
• – Quantity is valid.
• – A fuel quantity
discrepancy exists.
r
GX_11_011
EICAS PRIMARY DISPLAY
For Training Purposes Only
Sept 04
11-17
P I LOT T R A I N I N G GU I D E
FUEL SYSTEM
FLIGHT MANAGEMENT DISPLAY
When both engines are started, the Flight Management System (FMS) fuel quantity
switches from Fuel Quantity Gauge System (FMQGC) to FMS computed fuel
quantity, based on fuel flow data from the engines and APU.
Fuel quantity information to the FMS is used for monitoring and sensing, to assist in
determining a fuel leak. When a fuel leak is detected, a crew alert (“MSG” on the
Primary Flight Display) will be displayed and a message will appear on the scratchpad
of the FMS CDU.
COMPARE FUEL QUANTITY
0DEPARTURE
0PERFORMANCE INIT–LB 5/5
0BOW
51000
PASS/@ LB0
5/170
0FUEL (GAUGE) PASS WT00
25000 (23900) 8500
0CARGO GROSS WT00
200 770500
CONFIRM INIT0
COMPARE FUEL QUANTITY
0DEPARTURE T.O.INIT0
000ACTIVE FLT PLAN 1/4
0BOW PASS/@ LB0
0/170
0055°00154NM
15820 (00+21
0K0P0H0X0001152Z
SJN
0059°00121NM
15820 (00+15 .75M/10000A
CLS
ABQ
0ORIGIN
.75M/10000A
CLS
COMPARE FUEL
QUANTITY
Displays when
the gauge fuel
weight and the
FMS fuel weight
differ by more
than 2% of the
Basic Operating
Weight (BOW).
GX_11_012
P I LOT T R A I N I N G GU I D E
FUEL SYSTEM
11-18 For Training Purposes Only
Sept 04
ENGINE FEED SYSTEM
Fuel is provided to each engine from the two AC boost pumps. In normal operation,
both boost pumps are continuously on, and provide all engine fuel flow once the
engine is started. The AC pumps are located in the inboard section of each wing (feed
tank), and each AC pump is powered by a separate bus.
Loss of pressure at any AC boost pump causes the DC pump to come on, to provide a
back up of the remaining boost pump. The DC pumps also come on automatically for
takeoff, based on flaps/slats position and weight on wheels logic.
The engine fuel burn schedule is automatically controlled by the FMQGC to ensure
correct distribution for all airplane configurations.
The engine fuel burn sequence is as follows:
• Fuel from the wing tank will burn first
• When the wing tanks get below 93%, fuel transfers from the center tank to the
wing tank until it is at or above 97%
• When the center tank empties, fuel from the wing tanks continue to burn
• When either wing tank reaches 5,500 pounds, fuel transfers from the aft tank
• Once the aft tank is empty, the wing tanks will continue to burn the remaining fuel
Airplanes which do not incorporate fuel recirculation.
The engine fuel burn sequence is as follows:
• Fuel from the wing tanks will burn first
• When the wing tanks get below 93%, fuel transfers from the center tank to the
　
中國航空網(wǎng) www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：龐巴迪挑戰(zhàn)者手冊5(148)