1EFF : ALL 1 05-24-70Page 606 1 1 Feb 01/04 1 1 1CES 1
483AR,
487AR.
(2) Remove the access platform(s).
1EFF : ALL 1 05-24-70Page 607 1 1 Feb 01/05R 1 1 1CES 1
ZONAL INSPECTION : WING - INSPECTION/CHECK
__________________________________________
TASK 05-25-00-200-001
Zonal Inspection of the Wings as far as visible from the ground
1. Reason for the Job
__________________
R R Self Explanatory
2.
Job Set-up Information
______________________
Not Applicable
3.
Job Set-up
__________
Subtask 05-25-00-869-050
A. Not Applicable
4. Procedure
_________
Subtask 05-25-00-210-050
A. Inspection
(1)
Do a general visual inspection of the wing (zone 500 and zone 600) from the ground.
(2)
Make sure that there are no signs of corrosion, cracks or damage.
TASK 05-25-00-200-002
Zonal Inspection of the Wing Lower Surface including the Upper and Lower Surfaces of the Flaps and the Slats
1.
Reason for the Job
__________________
Refer to the MPD TASK: ZL-500-02
2.
Job Set-up Information
______________________
A. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
27-50-00-866-008 Extension of the Flaps on the Ground 27-50-00-866-009 Retraction of the Flaps on the Ground 27-80-00-866-004 Extending the Slats on the Ground 27-80-00-866-005 Retracting the Slats on the Ground
3. Job Set-up
__________ Subtask 05-25-00-866-050
A. Aircraft Maintenance Configuration WARNING : DO NOT EXTEND THE SLATS AND FLAPS WHEN THE THRUST REVERSER
_______
COWLS ARE DEPLOYED IN THE 45 DEG. POSITION.
(1) Fully extend the flaps and the slats (Ref. TASK 27-50-00-866-008) (Ref. TASK 27-80-00-866-004).
4. Procedure
_________ Subtask 05-25-00-210-051
A. Inspection
(1)
Do a general visual inspection of the wing lower surface (zones 500 and 600).
(2)
Make sure that there are no signs of corrosion, cracks or damage.
5. Close-up
________ Subtask 05-25-00-866-051
A. Aircraft Maintenance Configuration
(1) Retract the flaps and the slats (Ref. TASK 27-50-00-866-009), (Ref. TASK 27-80-00-866-005).
TASK 05-25-00-200-003
Zonal Inspection of the Wing Upper Surface including the Slats, the Flaps and the Spoilers
1. Reason for the Job
__________________
Refer to the MPD TASK: ZL-500-03
2. Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific access platform 3.50 m (11 ft. 6 in.)
B. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
27-50-00-866-008 Extension of the Flaps on the Ground 27-50-00-866-009 Retraction of the Flaps on the Ground 27-60-00-866-002 Extension-Retraction of the Spoilers for Maintenance 27-80-00-866-004 Extending the Slats on the Ground 27-80-00-866-005 Retracting the Slats on the Ground
3. Job Set-up
__________ Subtask 05-25-00-866-052
A. Aircraft Maintenance Configuration WARNING : DO NOT EXTEND THE SLATS AND FLAPS WHEN THE THRUST REVERSER
_______
COWLS ARE DEPLOYED IN THE 45 DEG. POSITION.
(1)
Extend the spoilers (Ref. TASK 27-60-00-866-002).
(2)
Fully extend the flaps and the slats (Ref. TASK 27-50-00-866-008) (Ref. TASK 27-80-00-866-004)
Subtask 05-25-00-941-050
B. Get Access
(1) Put an access platform in position at zone 500 and 600.
4. Procedure
_________ Subtask 05-25-00-210-052
A. Inspection
(1)
Do a general visual inspection of the wing upper surface (zones 500 and 600).
(2)
Make sure that there are no signs of corrosion, cracks or damage.
5. Close-up
________ Subtask 05-25-00-942-050
A. Close Access
(1) Remove the access platform(s). Subtask 05-25-00-866-053
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM 時間限制/維護檢查 1(71)
