曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

 METRIC ALTITUDE INDICATOR - REMOVAL/INSTALLATION
________________________________________________
 XA 1. _____________________
Referenced Procedures XA A. 24-22-00, Maintenance Practices (Apply Power) XA 2. ________________________________
Remove Metric Altitude Indicator XA A. Switch panel light control to OFF. XA B. Loosen instrument mounting clamp and slide indicator out of instrument XA panel. XA XA CAUTION:_______DRAW INDICATOR OUT OF INSTRUMENT PANEL WITH CARE TO AVOID XA STRESS AND/OR DAMAGE TO CABLE AND PNEUMATIC HOSE AT BACK OF XA CASE. XA XA PITOT AND STATIC SYSTEM PRESSURES MUST BE AT AMBIENT BEFORE XA PROCEEDING TO AVOID INSTRUMENT DAMAGE. XA XA C. Disconnect electrical connector on rear of indicator case. XA D. Disconnect static pressure hose from rear of indicator case by operating XA quick-disconnect fitting. XA 3. _________________________________
Install Metric Altitude Indicator XA A. Connect electrical cable to connector on rear of indicator case. XA XA CAUTION:_______TO AVOID INSTRUMENT DAMAGE, PITOT AND STATIC SYSTEM PRESSURES XA MUST BE AT AMBIENT BEFORE PROCEEDING. XA XA B. Connect static system hose to quick-disconnect fitting on rear of XA indicator case. XA C. Slide indicator into position in instrument panel and secure with XA instrument mounting clamp. XA XA CAUTION:_______INSERT INDICATOR INTO PANEL WITH CARE TO AVOID STRESS AND/OR XA DAMAGE TO CABLE AND PNEUMATIC HOSE. XA XA D. Check that panel light circuit breakers on panel P6 are closed and XA electrical power is provided (Ref 24-22-00). XA E. Switch panel light control to full bright. XA F. Check that instrument illumination lights are on. XA G. Remove electrical power if no longer required (Ref 24-22-00).
 EFFECTIVITY

 LH ALL    ATG Page 401  Aug 25/86

34-13-10
 MACH AIRSPEED WARNING SYSTEM - DESCRIPTION AND OPERATION
________________________________________________________
 1.  General (Fig. 1)
_______
 A.  The mach airspeed warning system provides an aural warning on the flight deck when the airplane exceeds its maximum operating limit. The warning system consists of a mach airspeed warning switch, warning clacker, and test switch. One system is installed in the airplane. In addition, a gear down dispatch airspeed switch is also installed. This switch, when selected, will provide an aural warning when the airplane speed exceeds 270 knots.
 B.  On airplanes with supplementary fuel tanks, a third airspeed warning switch is installed. The switch is active when either supplementary fuel tank is not empty and it will provide an aural warning whenever airspeed exceeds 342 knots.
 C.  Pitot and static air pressure (Ref 34-11-00, Pitot-Static System) control a pressure sensitive warning switch as a function of mach number or equivalent airspeed. When the maximum operating speed limit envelope is reached, the switch actuates a warning clacker at the flight engineer's station.
 D.  A test switch, located on the pilots' overhead panel P5, initiates an operational test.
 E.  The mach airspeed-gear down airspeed selector switch is installed. This switch allows connection of either the mach airspeed warning switch or the gear down dispatch airspeed warning switch to the clacker in the aural warning module.
 F.  System power is supplied from the 28-volt dc essential bus.
 2.  Mach Airspeed Warning Switch (Fig. 1)
____________________________
 A.  The mach airspeed warning switch is located on shelf E2-1 next to stanchion 3 in the main equipment center. The switch assembly contains a pressure-diaphragm operated airspeed switch and a clacker control relay.
 3.  Gear Down Dispatch Airspeed Switch
__________________________________
 A.  The gear down dispatch airspeed switch is located on shelf E2-1, next to the mach airspeed warning switch, in the main equipment center. The switch assembly is functionally identical to the mach airspeed warning switch, except that the setting of the switch is fixed at 270 knots.
 4.  Mach Airspeed-Gear Down Airspeed Selector Switch
_________________________________________________
 A.  The mach airspeed-gear down airspeed selector switch is installed near the gear down dispatch airspeed warning switch on shelf E2-1.
 B.  The selector switch is a two-position toggle switch. In NORMAL VMO position, the mach airspeed warning switch is connected to the system. In GEAR DOWN DISPATCH position, the gear down dispatch airspeed warning switch is connected to the system.
 5.  Fuel Tank Airspeed Waring Switch (ON AIRPLANES WITH SUPPLEMENTARY FUEL TANKS)
________________________________
 A.  The fuel tank airspeed warning switch is located on shelf E2-1, adjacent to the gear down dispatch warning switch. The switch assembly is functionally identical to the mach airspeed warning switch, except that the setting of the switch is at 342 knots.
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747飛機維護手冊AMM CHAPTER 34 - NAVIGATION 第34章導航1(86)