(2)
Make sure that the FWD-cargo compartment-door 825 is open (Ref. TASK 52-30-00-860-001).
(3)
Make sure that the CARGO COMPT LIGHT switch 6LU is at ON.
(4)
In the FWD cargo compartment, make sure that the panel 131HW is removed.
Subtask 30-71-17-865-054
C. Make sure that this(these) circuit breaker(s) is(are) open, safetied and tagged
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------
R C/B NOT APPLICABLE
4. Procedure
_________
(Ref. Fig. 401/TASK 30-71-17-991-002)
Subtask 30-71-17-420-051
A. Installation of the Sensor
(1)
On the waste water pipe, install the clamp sensor assembly (6) and the clamp (2) with the screws (4) and (5).
(2)
Tighten the screws (4) and (5).
(3)
Remove the blanking caps from the electrical connectors.
(4)
Make sure that the electrical connectors are clean and in the correct condition.
(5)
Connect the two wires of the clamp sensor assembly (6) to the terminal trip.
R 1EFF : 151-199, 401-499, 1 30-71-17Page 406 1 1 Config-2 Aug 01/05 1 1 1CES 1
(6)
Install the sleeve (3) around the clamp sensor assembly (6).
(7)
Make sure that the sleeve (3) is correctly installed around the clamp sensor assembly (6).
(8)
Install the velcro tape (1) to attach the sleeve (3) around the clamp sensor assembly (6).
(9) Install the new cable ties of the identification and warning labels. Subtask 30-71-17-865-055
B. Remove the safety clip(s) and the tag(s) and close this(these) circuit
breaker(s): R C/B NOT APPLICABLE
Subtask 30-71-17-710-050
C. Do the operational test of the waste-water ice-protection (Ref. TASK 30-71-00-710-002).
5. Close-up
________
Subtask 30-71-17-410-051
A. Close Access
(1)
Make sure that the work area is clean and clear of tool(s) and other items.
(2)
Install the panel 131HW.
(3)
Set the CARGO COMPT LIGHT switch 6LU to OFF.
(4)
Close the FWD-cargo compartment-door 825 (Ref. TASK 52-30-00-860-002).
(5) Remove the access platform(s).
Subtask 30-71-17-862-051
B. De-energize the ground service network
(Ref. TASK 24-42-00-862-001).
R 1EFF : 151-199, 401-499, 1 30-71-17Page 407 1 1 Config-2 Aug 01/05 1 1 1CES 1
SENSOR - TEMPERATURE (141DU) - REMOVAL/INSTALLATION
___________________________________________________ TASK 30-71-17-000-003 Removal of the Temperature Sensor (141DU)
1.
Reason for the Job
__________________
Self Explanatory
2.
Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific blanking caps
No specific circuit breaker(s) safety clip(s)
No specific access platform 2 m (6 ft. 7 in.)
B. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
24-42-00-861-001 Energize the Ground Service Network from the External Power 52-30-00-860-001 Open the FWD or AFT Cargo-Compartment Door with the Yellow Electric Pump 30-71-17-991-003 Fig. 401
3. Job Set-up
__________ Subtask 30-71-17-861-052
A. Energize the ground service network
(Ref. TASK 24-42-00-861-001).
1EFF : 301-399, 1 30-71-17Page 401 1 1 Config-3 Aug 01/05R 1 1 1CES 1
Subtask 30-71-17-865-059
B. Open, safety and tag this(these) circuit breaker(s):
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------
R 2000VU POT/WASTE WIP HEATER LINE 1DW A02 R 2000VU POT/WASTE WIP HEATER CTL 2DW A01
Subtask 30-71-17-010-056
C. Get Access
(1)
Put an access platform in position at the FWD-cargo compartment-door
中國航空網(wǎng) www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM ICE AND RAIN PROTECTION 防冰和排雨2(64)
